ALPINE SKI & SNOWBOARD PREPARATION

CERA F POWDER ROTO FLEECE APPLICATION
The initial steps before Cera F Roto Corking are the same as for the ironing in
method of Cera F.
It is recommended to have one separate Roto Fleece (T18F) for each different
Cera F.
Cera F applied with Roto Fleece is sometimes applied on top of ironed and
brushed Cera F as a “topping”.
1.
Apply Cera F evenly.
2.
Use a waxing iron to fix the Cera F powder to
the base. Iron temperature to be around 150°C
to 155°C (300°F to 310°F). Iron quickly, 3 to 4
seconds for one ski or board.
After cooling brush the powder up from
the base with the Horsehair Brush (T157).
Spray FC8A into the powder and let it dry.
3.
Use the Roto Fleece (T18F) at a speed of
approx. 1.500 RPM. Start from the tip and work
the Cera F powder into the base by moving the
drill back and forth approx. a foot at a time as
you work your way towards the tail. Use light
pressure. Let the skis/snowboard rest for
5 minutes at room temperature.
4.
Use the Horsehair Roto Brush (T16M) with
speed 1000/2000 RPM. Start from the tip and
move back and forth approx. a foot at a time
towards the tail. (OBS! Do not use the same
brush as for standard waxes.) Use light pressure.
5.
Continue with the Horsehair Roto Brush (T16M)
from tip to tail two more times in one movement
of four to five seconds.
6.
Finish with the Blue or White Nylon Roto Brush
(T17W). Twice in one continuous pass from tip
to tail in four to five seconds. Use light pressure.
(OBS! Do not use the same brush as on standard
waxes).
50 51