ALPINE SKI & SNOWBOARD PREPARATION
ALPINE SKI & SNOWBOARD PREPARATION
ALPINE SKI & SNOWBOARD PREPARATION
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
CERA F APPLICATION<br />
CORKED APPLICATION OF CERA F POWDER<br />
Complete edge filing and polishing. The base should be waxed and thoroughly<br />
brushed according to the steps outlined in the manual.<br />
1.<br />
Sprinkle an even layer of powder on the base.<br />
When corking, less powder is needed than for<br />
ironing. A layer of Cera F can also be applied by<br />
rubbing on a layer using Cera F Solid.<br />
2.<br />
Polish the powder into the base using a Cork<br />
(T20) or Cera F Polisher (T154) with Fiberlene.<br />
Use firm pressure back and forth so the cork<br />
will generate heat causing the powder to form<br />
a waxy film.<br />
3.<br />
Use the Wild Boar Brush (T164) or Horsehair<br />
Brush (T157). Use a firm back and forth scrubbing<br />
motion to furthe r polish the powder into<br />
the base pattern.<br />
4.<br />
Brush the powder out of the base with the Wild<br />
Boar Brush (T164) or Horsehair Brush (T157).<br />
10-20 strokes.<br />
5.<br />
Follow with more brushing using the Blue Nylon<br />
Polishing Brush (T160).<br />
Lightly wipe the base with Swix Fiberlene.<br />
5-10 strokes.<br />
6.<br />
Put the board or skis base down in the snow<br />
for a few minutes. This is usually done at the<br />
start site.<br />
Brush once again with the Blue Nylon Polishing<br />
Brush (T160) and lightly wipe with Fiberlene.<br />
5-10 strokes.<br />
46 47