ALPINE SKI & SNOWBOARD PREPARATION

ROTO BRUSHING WAX
When you have many skis to do Roto brushing can be timesaving.
You will need a drill that can do a minimum of 1000rpm and ideally up to
2000rpm or more. It is recommended to use protection eyewear.
ROTO BRUSHING CERA NOVA WAXES
After Scraping:
1.
Use the Steel Brush T179 from tip to tail in one
movement. Two repetitions.
2.
Use the T16M Horsehair Initial Roto Brush with
a speed of 1000rpm to 2000rpm. Use light
pressure. Start from the tip. Wax particles
should be thrown towards the tail. Move the
drill back and forth approx. a foot at the time as
you gradually work your way towards the tail.
3.
Continue to use the T16M Horsehair Roto Brush
(1000rpm/2000rpm) from tip to tail two more
times in one continuous pass of three to five
seconds.
SKI STRAPS FOR CARVING SKIS
With base protector. 50 mm height.
Takes skis 120 mm wide.
APRON
for professional waxers.
R0392 RA045
44 45
R0271
4.
Finish with the T17W Blue Nylon Roto Brush,
1000rpm/2000rpm. Make a continuous pass
three times from tip to tail in three to five seconds.
Now the ski or snowboard is ready or you can
start with application of Cera F.
BASE PROTECTOR
XS: 140 cm to 165 cm (SL).
S: 170 cm to 195 cm (GS).
D: up to 220 cm (DH/SG).
T220-13
WARM SLEEVES FOR ALPINE SKIS
This is an alternative to Hot Box heating.
Temperature is fixed at 55°C.
Recommended wax: CH10. Let sit for four hours
and your base is saturated with wax.