TERCERA ™ Owner's Manual - Del Mar Fans and Lighting

Direct - TouchAUTOMATIC DEMONSTRATION PROGRAMProgrammed into every Direct-Touch fan is an Automatic DemonstrationProgram. 1 It can 2 be used to fully demonstrate and test the operation of thefan. 041 32To enter the demonstration program:01. Turn the power button off for at least 5 seconds. This will clear4 3the fan memory ready for programming.2. Turn thepower button on.3. Immediately hold the "0" button for at least 5 seconds.A multi-tone signal will verify the start of the test program. The fan and1 2lights will go through a series of changing fan speeds, reversing the fanoperation mode, 0 turning off/on, and dimming the lights.4 3The complete cycle lasts slightly over one minute. It will continue torepeat until the is turned off for more than five seconds, cancellingthe program.1 2OPERATION SAFE-EXIT®The Safe-Exit 0 Program gives you about thirty seconds of light when you turn thelights off, 4 enabling 3 you to exit your home before the lights go out. To enter the Safe-Exit Program:1. Press the power button off for at least five seconds.Safe-Exit2. Turn the Power on. Immediately press and hold the "4" button for 5 seconds.When a light button is pressed, an audio tone and series of lights blinking will indicate the program1 2is active. When CFL mode is disabled, the Lights will stay on at 50% brightness for 20 seconds thendecrease in intensity for 30 seconds then 0turn off.4 33. With CFL mode active, the lights will turn off after 30 seconds.4. To cancel the Safe-Exit Program, press the1 2The Light-Minder Program automatically turns OFF the fan mounted 0 lights after twohours. To 1 enter 2the Light-Minder Program:4 301. To operate the lights for Light Minder Program – Turn the4 3for at least 5 seconds.power button off2. Turn the on. Immediately press and hold the "1" button for 5 seconds. Aseries of tones will be heard through the piezo-buzzer indicating the commandhas been accepted. Once the lights turn on, they will automatically turn off after2 hours.Light-Minder3. Light operation still remains normal, if you 1 leave 2the room and turn OFF thelights, the lights will blink to indicate the Light 0 Minder command has beenaccepted. The lights will stay on for 2 hours and then begin to dim. After thirty seconds have elapsed,4 3the lights will turn completely off. In CFL Mode, the lights will not dim, but shut off after 2 hours.4. To cancel the Light Minder Program, press thepower button and leave off for five seconds.LIGHT-MINDER® PROGRAMNote: With CFL mode active,the lights will not dim.power button and leave off for five seconds.21