Base Station Antenna Systems 2008 Product Selection Guide - AVW

Teletilt ® Remote Electrical Downtilt SystemRET Installation AccessoriesRound Member AdaptersStainless steel clamps to mount 0.5 to 4 in (13 to 102 mm) cable hangers to round supportmembers. Two each are needed for 3 and 4 in (76 and 102 mm) cable hangers. Kit of 10.Part NumberDiameter, in (mm)31670-1 1–2 (25–50)31670-2 2–3 (50–75)31670-3 3–4 (75–100)31670-4 4–5 (100–125)31670-5 5–6 (125–150)31670-6 6–8 (150–200) 31670 SeriesTower Standoff with Round Member AdapterAdapters with round member clamps and hardware for 0.5 to 4 in (13 to 102 mm) hangers. All partsare stainless steel or galvanized. Kit of 10.Part Number, 1 in (25 mm) Part Number, 2.5 in (60 mm) Diameter, in (mm)30848-5 — 0.75–1.5 (20–40)30848-4 — 1.5–3.0 (40–75)30848-1 41108A-1 3–4 (75–100)30848-2 41108A-2 4–5 (100–125)30848-3 41108A-3 5–6 (125–150)SnapStak Hanger with GrommetAndrew’s new SSHAK-38 SnapStak hanger provides a secure, robust installation for RET controlcable. This hanger is especially designed to reduce vibrations caused by the wind from affectingthe RET control cabling. Its unique retention tabs, located on the spring fork, highly resist pop-outoccurrences and allow motion to simply be absorbed. 30848 SeriesThe SSHAK-38 SnapStak hanger installs in 0.75 in (19 mm) holes in support structures 0.125 in(0.120 to 0.150 in) thick. Its stainless steel construction offers exceptional integrity, even in highlycorrosive environments and extreme weather conditions. No hardware is required for installation!Mounts to pre-punched 0.75 in (19 mm) holes. Kit includes ten SnapStak hangers and ten SSHA-38grommets.Part NumberDescriptionSSHAK-38SnapStak Hangers with SSHA-38 grommets for RET control cable,kit of 10SSHA-38 Grommets for RET control cable, kit of 10 SSHAK-38Andrew Wireless Solutions www.andrew.com93