12.07.2015 Views

Base Station Antenna Systems 2008 Product Selection Guide - AVW

Base Station Antenna Systems 2008 Product Selection Guide - AVW

Base Station Antenna Systems 2008 Product Selection Guide - AVW

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Teletilt ® Remote Electrical Downtilt SystemLightning Protection UnitTeletilt ® ATLP200-001 Lightning Protection UnitThe ATLP200-001 lightning protection unit provides added protection to all Teletilt systemcomponents. This unit is designed to withstand a short circuit current level of 10/350 μs, 16kA (lineto ground; per IEC 61312-1 standard). It is equipped with a grounding nut and must be grounded(ground cable included). Its 8-pin male and female AISG interfaces feed data and power through thecontroller to the first junction box, actuator/RET (remote electrical downtilt) device.Mounting brackets are included to allow the ATLP200-001 lightning protection unit to be mounted toeither a pole or a flat surface. ATLP200-001Lightning protection for ATC200 series remote controlvariable electrical downtilt systemPart NumberATLP200-001IncludesDescriptionLightning protection unit1 Pipe bracket1 Band clamp2 Wall bracket2 M8 carriage bolt, stainless steel, 25mm long2 M8 hex nut, stainless steel2 M8 lock washer, stainless steel1 Ground cable (#6 AWG with lugs), 2 ft (610 mm)1 Installation bulletinNote: Mounting brackets are included to allow the ATLP200-001 lightning protection unit to be mounted to eithera pole or a flat surface.ElectricalInternal lightning protectionOvercurrent protectionCircuit insertion resistanceProtected side clamping,nominal voltageEU certificationEMC/Surge immunitySafety standard EN 60950, UL 60950Gas discharge tube to ground protection: REA PE-80 compliant per testmethod IEEE C62.31Transorb and varistor secondary protection stageProtection rating (all lines to ground):IEEE C62.41.2 § 6.1.2 current pulse profile, 8/20 μs,200 repetitions min. at 600 AIEC 61312-1 annex B current pulse profile, 10/350 μs,10 repetitions min. at 600 APTC fuseSignal lines: under 1.0 ohm Power lines: under 0.5 ohmRS-485 lines: ± 10 V+12 V: +17 V to –0.6 V+24 V: +28 V to 0.6 V–48 V: +0.6 V to –58 VCE, CB; low voltage directive 73/23/EECETSI EN 300 386–V1.3.2 2003 with EN 55022 1998 schedule for classA device; GR 1089 core issue 3; FCC CFR 47 part 15 subpart B for classA; EN 61326-1, EN 5501172Andrew Wireless Solutions www.andrew.com

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!