70/140H-8 Series (2310KB) - TAIYO

Use of CAD/DATA
TAIYO CAD/DATA reflects customers’ requests.
TAIYO is currently supplying the third CAD/DATA that has been improved to reflect
customers’ various requests.
The improvement in the second CAD/DATA, comparing with the first CAD/DATA was
centered on the operation performance, while the retrieving performance was stressed in
the development of the third CAD/DATA, comparing with the second CAD/DATA.
Features of TAIYO CAD/DATA
1. Less number of the factors (data capacity)
constructing the diagrams of products
The diagrams of products comprise the minimum
factors necessary for machine design. Therefore,
the influences on the all diagrams (influences on
the data capacity) have been reduced even if the
products’ CAD/DATA are used on the diagram of
the machine.
The non-use of ellipses and spline curves limits the
increase of the factors even when data conversion
is performed.
Application for CAD/DATA
The CAD/DATA is available with no charge. If you request for the CAD/DATA, fill the application form below, and contact
your nearest TAIYO sales office.
Company name
Department, section
Official position
Name
Address
E-mail
Your CAD
system
CAD/DATA
supplying
Supplier of our
products
CAD system (software)
Computer model (hardware)
Required data
Supplying medium
Company name
• “MICRO CADAM” is the registered trademark of which exclusive right for use is owned by CADAMSYSTEMS CO.
“AUTO CAD” is the registered trademark of Autodesk, Inc. in the U.S.A.
• “DXF File” is the public data format of Autodesk, Inc. in the U.S.A.
2. Less number of diagrams (files)
ZIP CODE TEL FAX
The diagrams of products are classified into the
models to reduce the number of files for easier file
management and less labor in data conversion.
Application Form of TAIYO Series CAD/DATA Date of entry:
Charge sales office
Sales office code
Person in charge
Name
Ver. Manufacturer
Name
Manufacturer
MICRO CADAM
DXF
Others
CD-ROM
Others
AUTO CAD
Our remarks