70/140H-8 Series (2310KB) - TAIYO

55
General purpose hydraulic cylinder
70/140H-8
D
LC
70H-8 0 1 LC Bore B B Stroke – A B
140H-80 1 LC Bore B B Stroke – A B
E
A
C
TR
UA
● For the dimensions other than in the diagram above,
refer to the specification of the SD type (standard
type).
● For the mounting of switches, refer to the dimensional
drawings of “Switch set”. All the contents other than
“Switch mounting dimensions” are identical.
● The reinforcing plate is not being attached to the LC
mounting bracket in case of under 63mm bore.
With boots
Rod B • C
Nylon tarpaulin
Chloroprene
Conex
fWW
φ32 - φ100 :Max. 7
φ125 - φ150 :Max. 11
φ160 :Max. 13
B
AT
4-AB
⎞ ⎟⎟⎟⎠
AH
⎞ ⎟⎟⎟⎟⎠
AE
W
MM
KK
LIB
φ32 1/ 3 Stroke + X
φ40 • φ50 1/ 3.5 Stroke + X
φ63 - φ100 1/4 Stroke + X
φ125 - φ160 1/5 Stroke + X
φ32 1/2 Stroke + X
φ40 • φ50 1/2.5 Stroke + X
φ63 - φ100 1/3 Stroke + X
φ125 • φ140 1/3.5 Stroke + X
φ150 - φ160 1/4 Stroke + X
7/14 MPa double acting hydraulic cylinder
Double acting single rod/double rod Unit: mm
S
⎞
⎟
⎠
⎞
⎟
⎠
VD
B
A W FP
AO
SL
MM
AM
KK
LIB
2-EE
Double rod type (φ32 - φ160/rod B, C)
For both ends loaded type
A W FP
Material
Resistible
temperature
XA + stroke
PJ + stroke
Cushion valve
HL + stroke
SA + stroke
PJ + stroke
XM + stroke
SM + stroke
Standard
Nylon tarpaulin
80°C
Detail of LC mounting working face
(φ32 - φ80)
● The switch set (φ32 - φ140) is also within the fabrication range.
FP
W +
stroke
Semi-standard
Chloroprene
130°C
Conex
200°C
Notes) ● Remember that the resistible temperatures shown in the table above are for the
boots, not for the cylinder.
● Conex is the registered trademark of Teijin Ltd.
● If decimals are included into the calculation results, raise them to the next whole
number.
● The boots have been mounted at our factory prior to delivery.
LIB
AL
A
AO
KK
MM