REFERENCE MANUAL - J&H Licht en Geluid

PLATTER ASSEMBLY1. Remove NS7 from the packaging. Remove the two platter assemblies from package (underneath the NS7 controller).Place NS7 on a flat, stable surface for operation. Ensure unit has adequate air flow to all ventilation ports (especially if installed ina case).2. Place the platter onto the NS7 by aligning the pins in the bottom of the platter with the holes in the NS7’s motor.3. Place the slipmat onto the platter, then place the vinyl over the slipmat.4. Line up the notch in the spindle with the screw in the vinyl’s 45 RPM adapter. Use the allen wrench (included) to tighten the screw,locking the platter assembly to the spindle.2