REFERENCE MANUAL - J&H Licht en Geluid

NS7 CALIBRATIONIf you load new firmware to the NS7, or if you ever experience problems with your knobs or faders (a very rare occurrence), the NS7can be recalibrated. Follow these instructions to calibrate the unit.IMPORTANT NOTES:• When setting the knobs and faders during calibration, set the faders last (to ensure theydon’t accidentally move during adjustment).• When setting the knobs and faders, be sure they are all set at their endpoints. Slightinaccuracies could result in an incorrect calibration.• The MIC / AUX GAIN, BASS, and TREBLE knobs are analog controls and therefore notpart of the calibration.1. If you have uploaded new firmware, the left Deck’s HOT CUE BUTTON 1 will flash twice, indicating that you should recalibrate it.2. Disconnect the cable from the USB port and make sure the NS7 is off. While holding the right Deck’s HOT CUE BUTTONS 1 and3, turn the NS7’s power on. HOT CUE BUTTONS 1-5 should flash twice.3. Wait 10-20 seconds.4. Set all faders and knobs to the maximum or right-most position. The PITCH FADERS should be at the bottom, which is theirmaximum. (See image below.) The left Deck’s HOT CUE BUTTON 1 will light up.5. Press the lit left Deck’s HOT CUE BUTTON 1. It will flash twice.26