proform 385ex - Fitness Equipment

MAINTENANCE AND TROUBLE-SHOOTINGMost treadmill problems can be solved by following the steps below. Find the symptom that applies, andfollow the steps listed. If further assistance is needed, please call our Customer Service Department tollfreeat 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).PROBLEM: The power does not turn onSOLUTION: a. Make sure that the power cord is plugged into a surge protector, and that the surge protector isplugged into a properly grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page7.) Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet orless in length.b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.(See step 1 on page 8.)c. Check the circuit breaker located on the treadmillnear the power cord. If the switch protrudes asshown, the circuit breaker has tripped. To reset thecircuit breaker, wait for five minutes and then pressthe switch back in.cTrippedTrippedResetResetPROBLEM: The power turns off during useSOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see 1. c. above). Ifthe circuit breaker has tripped, wait for five minutes and then press the switch back in.b. Make sure that the power cord is plugged in.c. Remove the key from the console. Reinsert the key fully into the console. (See step 1 on page 8.)d. If the treadmill still will not run, please call our Customer Service Department, toll-free.PROBLEM: The displays of the console do not function properlySOLUTION: a. Check the batteries in the console. See BATTERY INSTALLATION on page 8. Most problems arethe result of drained batteries.b. Remove the six screws from the hood. Carefully removethe hood. Locate the Reed Switch (86) and theMagnet (87) on the left side of the Pulley (85). Turnthe Pulley until the Magnet is aligned with the ReedSwitch. Make sure that the gap between theMagnet and the Reed Switch is about 1/8Ó. If necessary,loosen the Screw (35) and move the ReedSwitch slightly. Retighten the Screw. Re-attach thehood, and run the treadmill for a few minutes to checkfor a correct speed reading.1/8Ó 85868735TopView12