The Internet Power Line Adapter - University of Queensland

More documents

Recommendations

Info

Home Automation, Power Lines and the Internet Quenten Alick The data rates achieved by the development boards were close to 9600 bits per second. This figure matches fairly closely with the specifications for the CEBus standard, which states that all command channel data should be transmitted at 10k bits per second regardless of medium. The reliability and noise / load immunity all relate to each other. Generally, the noise immunity was good. The testing was conducted in the Axon building, which has many pieces of electrical equipment & computers in use at one time. In tests it was found that the boards could communicate well across the entire building provided that they were on the same power phase. Overall, while on the same phase the boards achieved close to perfect data transmission. However, when a computer was plugged into the power lines between the two boards, the performance decreased. Computers are a special problem due to the large capacitance in their power supply. This capacitance tends to filter out the communications signal. When the boards used unacknowledged signals, the reliability of transmission dropped to almost zero. However, when the boards used the acknowledged modes, the reliability of transmission only dropped to 80-90%. This shows that using the more reliable modes, although slower, are much more effective even when large loads are being used in the circuit. The last sets of tests were conducted with the boards attempting to communicate across the different power phases in the building. The results from these tests indicated low reliability. However, it is impressive that there was any communication at all since the phases in the building are not directly coupled. Since some homes will use different phases for different parts of the house, it is important that power line communications for home automation systems must be able to communicate across phases. The normal solution for this is to directly couple the phases. This can be done with some commercially available devices, or more simply, a correctly rated capacitor can be connected across the two phases. This is usually sufficient to allow communication to occur. Unfortunately, we were unable to test this. - 30 -
Home Automation, Power Lines and the Internet Quenten Alick The next chapter will review the design and the design process. It will also look at what improvements could be made to this design in the future. - 31 -
Page 1 and 2: The Internet Power Line Adapter by
Page 3 and 4: Home Automation, Power Lines and th
Page 35: Home Automation, Power Lines and th
Page 43 and 44: Wall Module POWER SW3 J1 1 12 VAC V
Page 69: Home Automation, Power Lines and th

The Internet Power Line Adapter - University of Queensland

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?