V-Belts - Houston Bearing and Supply

Safety NoteWARNINGSafety must be considered a basic factor in machinery operation at all times. Mostaccidents are the result of carelessness or negligence. Power transmission productssuch as those listed in this catalog are potentially dangerous and must be guardedby the contractor, installer, purchaser, owner, and user as required by applicablelaws, regulations, standards, and good safety practice.Failure to follow proper procedures for installation, care, maintenance and storage ofproducts may result in failure to perform properly and may result in damage to propertyand serious bodily injury. Make sure that the product selected for any application isrecommended for that service.It is the responsibility of the contractor, installer, purchaser, owner, and user to install,maintain, and operate the parts or components manufactured and supplied byCarlisle Power Transmission Products, Inc., in such a manner as to comply with alloccupational safety laws, federal, state and local laws, ordinances, regulations, etc.CAUTIONGuards, access doors, and covers must be securely fastened before operating anyequipment. If parts are to be inspected, cleaned, observed, or general maintenanceperformed, the motor driving the part or components is to be locked out electrically insuch a manner that it cannot be started by anyone, however remote from the area.Failure to follow these instructions may result in property damage, personal injury, ordeath.AIRCRAFT WARNING!CARLISLE BELTS AND PULLEYS ARE NOT DESIGNED OR INTENDED FORAIRCRAFT USE. DO NOT USE CARLISLE PRODUCTS ON AIRCRAFTPROPELLER, ROTOR OR ACCESSORY DRIVES. DO NOT USE CARLISLEPRODUCTS ON HELICOPTERS OR PRIVATE, COMMERCIAL, OR ULTRA-LIGHT AIRCRAFT.