12.07.2015 Views

Pneumatic cylinders - Duncan Rogers

Pneumatic cylinders - Duncan Rogers

Pneumatic cylinders - Duncan Rogers

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

P1DOrder code keyInformation notes1) Code N for piston rod thread according to the ISOstandard.Other threads on request.2) P1D Clean without sensor function, see page 41.3) Only for P1D-F bore 80-125 mm. Select optional fittings inposition 20, see page 42.4) Only for P1D-F (Flexible Porting) bore 32-63 mm. Selectfittings in position 20, see page 42.5) Shaft or pivots square to or in line with the cylinder ports.6) For versions P1D-S and P1D-T.7) Only for P1D-T and P1D-S, XV-measure (from the pistonrod thread according to ISO to the centre of the pivots)stated in mm in positions 18-20 (max 999).20) Piston in extended position with unactuated valve.21) The standard cable length is 0.277 m. However, P1D Cleanis supplied with 1 m cable length.22) If stainless steel end cover screws are selected, the pistonrod nuts are also supplied in stainless steel.23) For operation with dry piston rod. Intended for variantsP1D-S, P1D-C, P1D-F, P1D-T and P1D-V24) The seal system for low pressure hydraulics demands ahard chromed surface for proper function.25) The metal scraper ring requires a hard-chromium platedpiston rod. Intended for variants P1D-S, P1D-T and P1D-V8) Valid only for <strong>cylinders</strong> with factory-fitted cylinder mountings.P1D Clean <strong>cylinders</strong> are always delivered with 4sealing plugs.9) P1D <strong>cylinders</strong> are always delivered with one piston rod nutin zinc-plated steel, except P1D Clean which is deliveredwith the piston rod nut in stainless steel. Codes X and Pmean that the cylinder is delivered with one additional nutof the same type.10) The piston rod nut in zinc-plated steel is replaced by a nutin stainless steel (P1D Clean is always delivered with onepiston rod nut in stainless steel).11) Left and right valid for P1D Standard and P1D Tie-Rodseen from behind with the ports on top. The sensors canonly be mounted on the left for P1D Flexible Porting.12) No factory-fitted sensors, but prepared for cable exit in thefront end (max. 2 sensors).13) No factory-fitted sensors, but prepared for cable exit in therear end (max. 2 sensors).14) No factory-fitted sensors, but prepared for cable exit inboth ends (max. 4 sensors).15) To choose speed control and fittings, please refer to page33 for P1D Standard and page 42 for P1D Flexible Porting.16) P1D Clean <strong>cylinders</strong> have factory installed nickel platedversions of the PTF series.17) Not available with P1D Flexible Porting bore 32-63 mm.18) Valid for bore 32-100 mm.19) Only for piston rod material type C and R.06.0582www.parker.com/euro_pneumatic

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!