12.07.2015 Views

RE2038 - Scott Technical Sales Company

RE2038 - Scott Technical Sales Company

RE2038 - Scott Technical Sales Company

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Material Safety Data SheetRevision Date: 06/23/2005 Issue date: 06/23/20051. CHEMICAL PRODUCT AND COMPANY IDENTIFICATIONProduct name: HYSOL <strong>RE2038</strong>;GAL Item No. : <strong>RE2038</strong>-B50 / IDH No. 500528Product type: Epoxy Resin Region: United States<strong>Company</strong> address:Henkel Corporation211 Franklin StreetOlean, New York 14760Contact Information:Telephone: 716.372.6300Emergency Telephone: 860.571.5100Internet: www.electronics.henkel.us2. COMPOSITION/INFORMATION ON INGREDIENTSHazardous components % ACGIH TLV OSHA PEL OTHEREpichlorohydrin-4,4'-isopropylidenediphenol resin25068-38-660-100 None None NoneOxirane, (butoxymethyl)-2426-08-610-30 3 ppm TWA(skin)270 mg/m³ TWA50 ppm TWANone3. HAZARDS IDENTIFICATIONEMERGENCY OVERVIEWHMIS:Physical state: Liquid HEALTH: 3*Color: Yellow FLAMMABILITY: 2Odor: Aromatic PHYSICAL HAZARD: 0Personal Protection: See Section 8WARNING:COMBUSTIBLE LIQUID AND VAPOR.MAY BE HARMFUL IF SWALLOWED, ABSORBED THROUGH SKIN OR INHALED.MAY CAUSE ALLERGIC SKIN AND RESPIRATORY REACTION.MAY CAUSE EYE, SKIN AND RESPIRATORY TRACT IRRITATION.Relevant routes of exposure:Inhalation, Eye contact, Skin contact, IngestionPotential Health EffectsInhalation:Skin contact:Eye contact:Ingestion:Existing conditions aggravated byexposure:May be harmful if inhaled. May cause allergic respiratory reaction.May be harmful if absorbed through skin. May cause allergic skin reaction. May cause skin irritation.May cause severe eye irritation. May cause corneal injury.May be harmful if swallowed.Eye, skin, and respiratory disorders.See Section 11 for additional toxicological information.Item No. : <strong>RE2038</strong>-B50 / IDH No. 500528 Product name: HYSOL <strong>RE2038</strong>;GAL1 of 4


4. FIRST AID MEASURESInhalation:Skin contact:Eye contact:Ingestion:Notes to physician:Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Getmedical attention.Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothingand shoes. Get medical attention. Wash clothing before reuse.Immediately flush eyes with plenty of water for at least 15 minutes. Check for and remove any contactlenses. Get medical attention.DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouthto an unconscious person. Obtain medical attention.In case of ingestion, the stomach should be emptied by gastric lavage under qualified medicalsupervision.Flash point: 73°C (163°F) Setaflash5. FIRE-FIGHTING MEASURESAutoignition temperature:Flammable/Explosive limits-lower %:Flammable/Explosive limits-upper %:Extinguishing media:Special fire fighting procedures:Unusual fire or explosion hazards:Hazardous combustion products:Not availableNot availableNot availableWater spray (fog), foam, dry chemical or carbon dioxide.Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Watershould be used to cool closed containers to prevent pressure build-up and possible autoignition orexplosion when exposed to extreme heat.In the event of fire, cool tanks with water spray.Oxides of carbon. Irritating organic vapors. Hydrogen chloride. Phenolics.6. ACCIDENTAL RELEASE MEASURESEnvironmental precautions:Clean-up methods:Prevent product from entering drains or open waters.Evacuate and ventilate spill area; dike spill to prevent entry into water system; wear full protectiveequipment during clean-up. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder,universal binder, sawdust). Keep in suitable and closed containers for disposal. Flush area with waterto remove trace residue.7. HANDLING AND STORAGEHandling:Storage:Use only with adequate ventilation. During use and until all vapors are gone: Keep area ventilated - donot smoke; extinguish all flames, pilot lights, and heaters; turn off stoves, electrical tools andappliances, and any other sources of ignition. Keep away from heat, spark and flame. Avoid contactwith eyes, skin and clothing. Avoid breathing vapor and mist. Wash thoroughly after handling. Makesure containers are properly grounded before use or transfer of material.Keep in a cool, well ventilated area away from heat, sparks and open flame. Keep container tightlyclosed until ready for use.Incompatible products: Refer to Section 10.For information on product shelf life contact Henkel Customer Service at 1-716-372-6300.8. EXPOSURE CONTROLS / PERSONAL PROTECTIONEngineering controls:Respiratory protection:Use local exhaust ventilation to maintain airborne concentrations below established exposure limits.Use NIOSH approved respirator if there is potential to exceed exposure limit(s).Item No. : <strong>RE2038</strong>-B50 / IDH No. 500528 Product name: HYSOL <strong>RE2038</strong>;GAL2 of 4


Skin protection:Eye/face protection:Use chemical resistant, impermeable clothing including gloves and either an apron or body suit toprevent skin contact.Chemical splash goggles or safety glasses with side shields. In a splash hazard environment, chemicalgoggles should be used in combination with a full face shield.Physical state:LiquidColor:YellowOdor:AromaticVapor pressure:0.4 kPa at 25 ºC (77 ºF)pH:Not availableBoiling point/range:Not availableMelting point/range:Not availableSpecific gravity: 1.13Vapor density: 4.5 (air equals 1)Evaporation rate:Not availableSolubility in water:Negligible.Partition coefficient (n-octanol/water): Not availableVOC content:Not availableSee Section 2 for exposure limits.9. PHYSICAL AND CHEMICAL PROPERTIES10. STABILITY AND REACTIVITYStability:Hazardous polymerization:Hazardous decomposition products:Incompatability:Conditions to avoid:Stable at normal conditionsNone under normal processing.None reasonably foreseeableStrong oxidizing agents. Oxides of carbon and nitrogen, strong oxidizing agents, strong lewis ormineral acids, strong organic bases. Primary and secondary aliphatic amines. Curing agents.High temperatures. Avoid static discharge. Keep away from open flames, hot surfaces and sources ofignition. Storage with incompatible materials.11. TOXICOLOGICAL INFORMATIONCarcinogen StatusHazardous components NTP Carcinogen IARC Carcinogen OSHA CarcinogenEpichlorohydrin-4,4'-isopropylideneNo No Nodiphenol resin25068-38-6Oxirane, (butoxymethyl)-2426-08-6No No NoLiterature Referenced Target Organ & Other Health EffectsHazardous componentsEpichlorohydrin-4,4'-isopropylidenediphenol resin25068-38-6Oxirane, (butoxymethyl)-2426-08-6Health Effects/Target OrgansAllergen, IrritantMutagen, Liver, Irritant, Central nervous system, Allergen12. ECOLOGICAL INFORMATIONEcological information:Not availableItem No. : <strong>RE2038</strong>-B50 / IDH No. 500528 Product name: HYSOL <strong>RE2038</strong>;GAL3 of 4

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!