Quad 33 manual - n-1

The plug-in Tape Adaptor Board provides threealternative signal level settings each for recording andreplay on both channels, by means of small screwsinserted from the underside of the board into the appropriateposition for the signal level of the tape recorderto be used. (See Fig. 9 and Specification on Pages 20and 2l').Scr€ws for adju$ing outpu!lrcm Ou6d 33rotam r€coderL6fthandchannolIn$dthi6dgsinlo r€ar ofcontol UntrRigh! hand channclFIG. 9Normally either one or both tape sockets may be usedfor recording and replay as convenient the (L) and (R)pins (See Fig. 7) of the record socket being linked insidethe control unit to the corresponding pins of the replaysocket. Where the levels and impedances are such thatcross-talk can appear in the cables and connectors itwill be advisable to use completely separate connectionsfor recording and replay.Mains OutletsThese sockets are intended for supplying the Quad303 power amplifier and the FM stereo tuner. Normallyit will be more convenient to run the mains supply directto tape recorder and gramophone motor since theseincorporate their own on/off switching, but if otherunits are run off the Quad 33 mains outlets the totalcurrent drawn must not exceed 2 amps.Mains InputA 3-pin connector is provided for the control unitand this should be wired to the mains supply using asuitable grade of flexible cable. In countries where anearth connection is not used or where an external earthis connected to the E terminal of the control unit thethird pin of the plug should be left blank.Pape Ten