FlexPendant Operators Manual 3HAC16590 ... - Technology

3 Get started3.3.2. System start upContinuedStep Action Info7. This step is only required if the robotsystem will be connected to a network.Use the boot application to:• set the IP address of thecontroller cabinet• set the network connections• select the system• restart the systemThe system is restarted.How to use the boot application isdetailed in section Using the bootapplication on page 254.At this point, a single system isavailable.8. Install RobotStudio Online on a PC. Proceed as detailed in section InstallingRobotStudio Online in the Operator’smanual - RobotStudio Online.RobotStudio Online is used to create asystem to run on the controller, but atthis point (prior to the first start-up) asystem is already installed by themanufacturer.9. Connect the controller to a PC (throughthe service port) or to the network (ifused).Connect a PC to the ControlModuleservice port.Proceed as detailed in sectionConnecting a PC to the service port onpage 52.Also see section Set up the networkconnection on page 54.10. Start RobotStudio Online on the PC. Proceed as detailed in sectionAccessing a controller fromRobotStudio Online in the Operator’smanual - RobotStudio Online.11. Restart the controller.12. The robot system is now ready foroperation.583HAC 16590-1 Revision: B