FlexPendant Operators Manual 3HAC16590 ... - Technology

3 Get started3.2.3. Connecting a PC to the service port3.2.3. Connecting a PC to the service portNOTE!The service port shall only be used for direct connection to a PC as described in thisprocedure. It must not be connected to a LAN (local area network), since it has a DHCP serverthat automatically distributes IP addresses to all units connected to the LAN. Contact yournetwork administrator if you need more information.CAUTION!When a cable is connected to the service port on the Control Module front and the servicehatch is opened, the controller will not comply with the requirements of protection class IP54.PortsThe illustration below shows the two main ports on the computer unit: the Service Port andthe LAN port. Make sure the LAN (factory network) is not connected to any of the serviceports!xx0400001299ABCService port on the Control Module frontService port on computer unit (connected to Service port on the Control Modulefront through a cable)LAN port on computer unit (connects to factory LAN)Connections to ports may be done as detailed below:Connection to/from:Connecting the Control Module to thefactory LANConnecting a PC to the Control Moduleservice port.Detailed in section:Proceed as detailed in section Installation inthe Product Manual, IRC5.Proceed as detailed below!52Continues on next page3HAC 16590-1 Revision: B