FlexPendant Operators Manual 3HAC16590 ... - Technology

12 Changing FlexPendant settings12.4. Configuring Most Common I/O12.4. Configuring Most Common I/OMost Common I/OMost Common I/O is used in the Program Editor to display a list of the most commonly usedI/O signals in the robot system. Since there can be many signals, it may be very helpful to beable to make this selection.The sorting in the list can be rearranged manually. By default, the signals are sorted in theorder that they are created.Most Common I/O can also be configured using system parameters in the topic Man-machineCommunication. However, sorting the list can only be done by using the function under theControl Panel. See section Configuring system parameters on page 270.Configuring Most Common I/OThis section describes how to configure the list Most Common I/O.StepAction1. On the ABB menu, tap Control Panel.2. Tap I/O.A list of all I/O signals defined in the system is listed with checkboxes.3. Tap the names of the signals to select for the Most Common I/O list.Tap All or None to select all or no signals.Tap Name or Type to sort by name or signal type.4. Tap Preview to see the list of selected signals and adjust the sort order.Tap to select a signal and then tap the arrows to move the signal up or down inthe list, rearranging the sort order.Tap APPLY to save the sort order.Tap Edit to return to the list of all signals.5. Tap APPLY to save the settings.3HAC 16590-1 Revision: B289