Assembly instructions - KLARO GmbH

Assembly instructions for KLARO retrofit kits1. Product description1.1. Field of applicationThe retrofit kit consists of a machine cabinet and the installation parts for the existing pit. It isused e.g. retrofitting an existing multiple-chamber to a fully biological wastewater treatmentplant. The assembly and installation instructions of the cabinet must also be followed.1.2. TransportThe retrofit kits are delivered in cardboard packaging. Where necessary, information abouthandling the packaged products is provided on the cardboard boxes (See example providedin Figure 1). In order to avoid any damage, this information must be observed both fortransport and for storage! Proven non-compliance will result in any warranty claims beingdeclared void.Figure 1: Information on the packaging1.3. Inspection of the delivery / scope of deliveryOn the basis of the delivery note, all parts must be checked for completeness and for anydamage in transit immediately after delivery. We will not accept any complaints that aresubmitted at a later time. Damaged parts must not be installed.In general, the supplied retrofit kit consists of the following components: 1 charging lift, DN 50 / 70, made of HT, marked in red; 1 clearwater lift, DN 50 / 70, made of HT, marked in black; 1 or more excess sludge lift(s), DN 50, made of HT, marked in white; Aeration unit(s) with piping made of stainless steel with diaphragm pipes or discsmade of EPDM, with fine perforation; Accessories box with assembly materials for lifts and ventilation unit(s); Submerged foil; Sampling unit (optional); Air hoses (optional); UV module (optional); Switch cabinet with Klaro control unit.1.4. StorageThe place of storage should be dry and protected against harmful environmental influences(e.g. UV light) and external influences.KLARO GmbH 3