Owner's Manual - Roland

Creating a Rhythm SetA-Env Level 1–3 (TVA Envelope Level 1–3) 3Specify the TVA envelope levels (Level 1–Level 3). These settingsspecify how the volume will change at each point, relative to thestandard volume (the Rhythm Tone Level value specified in the TVAscreen).Value: 0–127fig.06-041.eT1 T2 T3 T4Tone Out AssignSpecifies how the direct sound of each tone will be output.Value:MFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passesthrough multi-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT Bjack in stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in monowithout passing through multi-effects.LevelTimeL1 L2L3Note onNote offT: Time L: LevelOutput Settings (Output)fig.07-014_50For details on these settings, refer to “How to make RhythmSet settings” (p. 83).Rhythm Out AssignSpecifies for each rhythm set how the direct sound will be output.Value:MFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passesthrough multi-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT Bjack in stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in monowithout passing through multi-effects.If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.If the Rhythm Output Assign is set to anything other than“TONE,” these settings will be ignored.If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.* If the Mix/Parallel parameter is set to “MIX,” all sounds are outputfrom the OUTPUT A (MIX) jacks in stereo (p. 230).* If you've set Tone Out Assign to “MFX,” set the MFX OutputAssign parameter (p. 208) to specify the output destination of thesound that has passed through the multi-effects.* Chorus and reverb are output in mono at all times.* The output destination of the signal after passing through the chorusis set with the Chorus Output Select (p. 209) and the Chorus OutputAssign (p. 209).* The output destination of the signal after passing through the reverb isset with the Reverb Output Assign (p. 212).Tone Out LevelSet the level of the signal that is sent to the output destinationspecified by Patch/Tone Output Assign.Value: 0–127Tone Chorus Send (Send Level (Output=MFX))1Specifies the level of the signal sent to the chorus for each tone if thetone is sent through MFX.Value: 0–127Tone Reverb Send (Send Level (Output=MFX))2Specifies the level of the signal sent to the reverb for each tone if thetone is sent through MFX.Value: 0–127If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).95