Owner's Manual - Roland

Creating a PatchBiasBias causes the volume to be affected by the keyboard position. Thisis useful for changing volume through keyboard position (pitch)when playing acoustic instruments.fig.06-039.eLOWERUPPERLevel +Level0–KeyBias PositionC-1 G9Bias PositionC-1 G9–0+KeyPan Key Follow 3Use this parameter if you want key position to affect panning.Positive (+) settings will cause notes higher than C4 key (center C) tobe panned increasingly further toward the right, and negative (-)settings will cause notes higher than C4 key (center C) to be pannedtoward the left. Larger settings will produce greater change.Value: -100– +100fig.06-040.ePanR+100LO&UPLevel +0–Bias PositionC-1 G9–0+ALL–Level0KeyBias Position+C-1 G9–0+Keyo+500-50Bias LevelAdjusts the angle of the volume change that will occur in theselected Bias Direction. Larger settings will produce greater change.Negative (-) values will invert the change direction.Value: -100, -90, -80, -70, -60, -50, -40, -30, -20, -10, 0, +10,+20, +30, +40, +50, +60, +70, +80, +90, +100Bias PositionSpecifies the key relative to which the volume will be modified.Value: C-1–G9Bias DirectionSelects the direction in which change will occur starting from theBias Position.ValueLOWER: The volume will be modified for the keyboard areabelow the Bias Point.UPPER: The volume will be modified for the keyboard areaabove the Bias Point.LO&UP: The volume will be modified symmetrically towardthe left and right of the Bias Point.ALL: The volume changes linearly with the bias point atthe center.Tone Pan ★ 2Sets the pan of the tone. “L64” is far left, “0” is center, and “63R” isfar right.Value: L64–0–63RL-100C1 C2 C3 C4 C5 C6 C7Random Pan DepthUse this parameter when you want the stereo location to changerandomly each time you press a key. Higher settings will produce agreater amount of change.Value: 0–63Alter Pan Depth (Alternate Pan Depth)This setting causes panning to be alternated between left and righteach time a key is pressed. Higher settings will produce a greateramount of change. “L” or “R” settings will reverse the order inwhich the pan will alternate between left and right. For example iftwo tones are set to “L” and “R” respectively, the panning of the twotones will alternate each time they are played.Value: L63–0–63RWhen any value from Type “2”–”10” is selected for theStructure parameter in the Pan KF, Rnd Pan Depth, Alter PanDepth parameter settings, the output of tones 1 and 2 are joinedin tone 2, and the output of tones 3 and 4 are joined in tone 4.For this reason, tone 1 will follow the settings of tone 2, andtone 3 will follow the settings of tone 4 (p. 63).TVA EnvA-Env T1 V-Sens (TVA Envelope Time 1Velocity Sensitivity)This allows keyboard dynamics to affect the Time 1 of the TVAenvelope. If you want Time 1 to be speeded up for strongly playednotes, set this parameter to a positive (+) value. If you want it to beslowed down, set this to a negative (-) value.Value: -63– +634Key72