Owner's Manual - Roland

Playing in Patch ModeLFO Osc 1 Pitch DepthSpecifies the depth to which the LFO will modulate the OSC1 pitch.Value: -63–+63LFO Osc 2 Pitch DepthD Beam (Assignable)By assigning a variety of functions to the D Beam controller you canapply different effects to the sound in real time.fig.05-020_50Specifies the depth to which the LFO will modulate the OSC2 pitch.Value: -63–+63LFO Osc 1 Pulse Width DepthSpecifies the depth to which the LFO will modulate the pulse widthof the OSC1 waveform.* The Pulse Width is activated when “SQR” is selected with OSC1/2waveform.Value: -63–+63LFO Osc 2 Pulse Width DepthSpecifies the depth to which the LFO will modulate the pulse widthof the OSC2 waveform.* The Pulse Width is activated when “SQR” is selected with OSC1/2waveform.Value: -63–+63Range (Solo synth range)Specifies the range in which the pitch of the solo synth will vary.Value: 2 OCTAVES, 4 OCTAVES, 8 OCTAVESFor details on these settings, refer to “Assigning a Parameterto a Controller” (p. 48).TypeSpecifies the function controlled by the D Beam controller.ValueCC01–31, 33–95: Controller numbers 1–31, 33–95For more information about Control Change messages, pleaserefer to “MIDI Implementation” (p. 298).Bend Up: Raises the pitch in semitone steps (up to 4octaves higher).Bend Down: Lowers the pitch in semitone steps (up to 4octaves lower).Start/stop:Starts/Stops the sequencer.TAP Tempo: Tap tempo (a tempo specified by the intervalat which you move your hand over the DBeam controller).Arp Grid:Arpeggio GridArp Duration: Adjusts the duration of each arpeggiatednoteArp Motif:Arpeggio MotifArp Oct Up:The range in which the arpeggio is soundedwill rise in steps of an octave (maximum 3octaves).Arp Oct Down: The range in which the arpeggio is soundedwill lower in steps of an octave (maximum 3octaves).Range Min (D Beam Range Lower)Specify the lower limit of the range of the D Beam controller.Value: 0–127Range Max (D Beam Range Upper)Specify the upper limit of the range of the D Beam controller.Bysetting Range Max below Range Min you can invert the range ofchange.Value: 0–12750