Owner's Manual - Roland

Effects List35: OVERDRIVECreates a soft distortion similar to that produced by vacuum tubeamplifiers.fig.MFX-35L inR inParameter Value DescriptionDrive # 0–127 Degree of distortionAlso changes the volume.Amp Type36: DISTORTIONProduces a more intense distortion than Overdrive. The parametersare the same as for “35: OVERDRIVE.”fig.MFX-3637: VS OVERDRIVEThis is an overdrive that provides heavy distortion.fig.MFX-3738: VS DISTORTIONThis is a distortion effect that provides heavy distortion. Theparameters are the same as for “37: VS OVERDRIVE.”fig.MFX-38SMALL,BUILT-IN,2-STACK,3-STACKType of guitar ampSMALL: small ampBUILT-IN: single-unit type amp2-STACK: large double stack amp3-STACK: large triple stack ampLow Gain -15– +15 dB Gain of the low rangeHigh Gain -15– +15 dB Gain of the high rangePan # L64–63R Stereo location of the output soundLevel 0–127 Output LevelL inR inL inR inParameter Value DescriptionDrive # 0–127 Degree of distortionAlso changes the volume.Tone # 0–127 Sound quality of the Overdrive effectAmp Sw OFF, ON Turns the Amp Simulator on/off.Amp TypeOverdriveDistortionOverdriveSMALL,BUILT-IN,2-STACK,3-STACKAmpSimulatorAmpSimulatorAmpSimulator2-BandEQ2-BandEQ2-BandEQL outPan LPan RR outL outPan LPan RR outL outPan LPan RR outType of guitar ampSMALL: small ampBUILT-IN: single-unit type amp2-STACK: large double stack amp3-STACK: large triple stack ampLow Gain -15– +15 dB Gain of the low rangeHigh Gain -15– +15 dB Gain of the high rangePan # L64–63R Stereo location of the output soundLevel 0–127 Output LevelL inR inDistortionAmpSimulator2-BandEQL outPan LPan RR out39: GUITAR AMP SIMULATORThis is an effect that simulates the sound of a guitar amplifier.fig.MFX-39L inR inParameter Value DescriptionPre Amp Sw OFF, ON Turns the amp switch on/off.Pre Amp JC-120, CLEAN TWIN, Type of guitar ampTypeMATCH DRIVE,BG LEAD, MS1959I,MS1959II, MS1959I+II,SLDN LEAD,METAL5150,METAL LEAD, OD-1,OD-2 TURBO,DISTORTION, FUZZPre AmpVolume #0–127 Volume and amount of distortionof the ampPre Amp 0–127 Volume of the entire pre-ampMaster #Pre AmpGainLOW, MIDDLE, HIGH Amount of pre-amp distortionPre AmpBassPre AmpMiddlePre AmpTreblePre AmpPresencePre AmpBrightPre Amp0–127 Tone of the bass/mid/treblefrequency range* Middle cannot be set if“Match Drive” is selected asthe Pre Amp Type.0–127(MATCH DRIVE:-127 - 0)OFF, ONSpeakerL outPan LPan RR outTone for the ultra-high frequencyrangeTurning this “On” produces asharper and brighter sound.* This parameter applies tothe “JC-120,” “Clean Twin,”and “BG Lead” Pre AmpTypes.Speaker Sw OFF, ON Determines whether the signalpasses through the speaker(ON), or not (OFF).Speaker (See the table below.) Type of speakerTypeMic Setting 1, 2, 3 Adjusts the location of the micthat’s capturing the sound ofthe speaker.This can be adjusted in threesteps, from 1 to 3, with themic becoming more distantas the value increases.Mic Level 0–127 Volume of the microphoneDirect Level 0–127 Volume of the direct soundPan # L64–63R Stereo location of the outputLevel # 0–127 Output levelSpecifications for each Speaker TypeThe speaker column indicates the diameter of each speaker unit (ininches) and the number of units.Type Cabinet Speaker MicrophoneSMALL 1 small open-back enclosure 10 dynamicSMALL 2 small open-back enclosure 10 dynamicMIDDLE open back enclosure 12 x 1 dynamicJC-120 open back enclosure 12 x 2 dynamicBUILT-IN 1 open back enclosure 12 x 2 dynamicBUILT-IN 2 open back enclosure 12 x 2 condenserBUILT-IN 3 open back enclosure 12 x 2 condenserBUILT-IN 4 open back enclosure 12 x 2 condenserBUILT-IN 5 open back enclosure 12 x 2 condenserBG STACK 1 sealed enclosure 12 x 2 condenserBG STACK 2 large sealed enclosure 12 x 2 condenserMS STACK 1 large sealed enclosure 12 x 4 condenserMS STACK 2 large sealed enclosure 12 x 4 condenserMETAL large double stack 12 x 4 condenserSTACK2-STACK large double stack 12 x 4 condenser3-STACK large triple stack 12 x 4 condenser281