Owner's Manual - Roland

Effects List26: HEXA-CHORUSUses a six-phase chorus (six layers of chorused sound) to giverichness and spatial spread to the sound.fig.MFX-26L inR inParameter Value DescriptionPre Delay 0.0–100.0 ms Adjusts the delay time from thedirect sound until the chorussound is heard.Rate # 0.05–10.00 Hz, note Frequency of modulationDepth 0–127 Depth of modulationPre DelayDeviationDepthDeviation27: TREMOLO CHORUSThis is a chorus effect with added Tremolo (cyclic modulation ofvolume).fig.MFX-270–20 Adjusts the differences in PreDelay between each chorussound.-20– +20 Adjusts the difference in modulationdepth between each chorussound.Pan Deviation 0–20 Adjusts the difference in stereolocation between each chorussound.0: All chorus sounds will be inthe center.20: Each chorus sound will bespaced at 60 degree intervalsrelative to the center.Balance # D100:0W–D0:100W Volume balance between the directsound (D) and the chorussound (W)Level 0–127 Output LevelL inR inBalance DHexa ChorusBalance DBalance DTremolo ChorusBalance DL outBalance WBalance WR outL outBalance WBalance WR outParameter Value DescriptionPre Delay 0.0–100.0 ms Adjusts the delay time fromthe direct sound until the chorussound is heard.Chorus Rate # 0.05–10.00 Hz, note Modulation frequency of thechorus effectChorus Depth 0–127 Modulation depth of the choruseffectTremolo Rate # 0.05–10.00 Hz, note Modulation frequency of thetremolo effectTremolo 0–127 Spread of the tremolo effectSeparationTremolo Phase 0–180 deg Spread of the tremolo effectBalance # D100:0W–D0:100W Volume balance between thedirect sound (D) and the tremolochorus sound (W)Level 0–127 Output Level28: SPACE-DThis is a multiple chorus that applies two-phase modulation instereo. It gives no impression of modulation, but produces atransparent chorus effect.fig.MFX-28L inR inParameter Value DescriptionPre Delay 0.0–100.0 ms Adjusts the delay time fromthe direct sound until thechorus sound is heard.Rate # 0.05–10.00 Hz, note Frequency of modulationDepth 0–127 Depth of modulationPhase 0–180 deg Spatial spread of the soundLow Gain -15– +15 dB Gain of the low rangeHigh Gain -15– +15 dB Gain of the high rangeBalance # D100:0W–D0:100W Volume balance betweenthe direct sound (D) and thechorus sound (W)Level 0–127 Output Level29: 3D CHORUSThis applies a 3D effect to the chorus sound. The chorus sound willbe positioned 90 degrees left and 90 degrees right.fig.MFX-29LRSpace DSpace DBalance DBalance D3D ChorusBalance WBalance W2-BandEQ2-BandEQ2-BandEQ2-BandEQL outR outL outR outParameter Value DescriptionFilter Type OFF, LPF, HPF Type of filterOFF: no filter is usedLPF: cuts the frequencyrange above the Cutoff FreqHPF: cuts the frequencyrange below the Cutoff FreqCutoff Freq 200–8000 Hz Basic frequency of the filterPre Delay 0.0–100.0 ms Adjusts the delay time from thedirect sound until the chorussound is heard.Rate # 0.05–10.00 Hz, note Frequency of modulationDepth 0–127 Modulation depth of the choruseffectPhase 0–180 deg Spatial spread of the soundOutput Mode SPEAKER, PHONES Adjusts the method that will beused to hear the sound that isoutput to the OUTPUT jacks.The optimal 3D effect will beachieved if you select SPEAK-ER when using speakers, orPHONES when using headphones.Low Gain -15– +15 dB Gain of the low rangeHigh Gain -15– +15 dB Gain of the high rangeBalance # D100:0W–D0:100W Volume balance between thedirect sound (D) and the chorussound (W)Level 0–127 Output Level278