Owner's Manual - Roland

Effects List05: SUPER FILTERThis is a filter with an extremely sharp slope. The cutoff frequencycan be varied cyclically.fig.MFX-05L inR inParameter Value DescriptionFilter Type LPF, BPF,HPF, NOTCHFilter typeFrequency range that will passthrough each filterLPF: frequencies below the cutoffBPF: frequencies in the region of thecutoffHPF: frequencies above the cutoffNOTCH: frequencies other than theregion of the cutoffFilter Slope -12, -24, -36 dB Amount of attenuation per octave-36 dB: extremely steep-24 dB: steep-12 dB: gentleFilterCutoff #FilterResonance #Super FilterSuper Filter0–127 Cutoff frequency of the filterIncreasing this value will raise thecutoff frequency.0–127 Filter resonance levelIncreasing this value will emphasizethe region near the cutoff frequency.Filter Gain 0– +12 dB Amount of boost for the filter outputModulation OFF,ON On/off switch for cyclic changeSwModulationWaveTRI, SQR,SIN, SAW1,SAW2SAW1L outR outHow the cutoff frequency will be modulatedTRI: triangle waveSQR: square waveSIN: sine waveSAW1: sawtooth wave (upward)SAW2: sawtooth wave (downward)SAW2Rate # 0.05–10.00 Hz, Rate of modulationnoteDepth 0–127 Depth of modulationAttack # 0–127 Speed at which the cutoff frequencywill changeThis is effective if Modulation Waveis SQR, SAW1, or SAW2.Level 0–127 Output level06: STEP FILTERThis is a filter whose cutoff frequency can be modulated in steps.You can specify the pattern by which the cutoff frequency willchange.fig.MFX-06L inR inParameter Value DescriptionStep 01–16 0–127 Cutoff frequency at each stepRate # 0.05–10.00 Hz, Rate of modulationnoteAttack # 0–127 Speed at which the cutoff frequencychanges between stepsFilter Type LPF, BPF,HPF, NOTCHFilter typeFrequency range that will passthrough each filterLPF: frequencies below the cutoffBPF: frequencies in the region of thecutoffHPF: frequencies above the cutoffNOTCH: frequencies other than theregion of the cutoffFilter Slope -12, -24, -36 dB Amount of attenuation per octave-12 dB: gentle-24 dB: steep-36 dB: extremely steepFilterResonance #07: ENHANCERControls the overtone structure of the high frequencies, addingsparkle and tightness to the sound.fig.MFX-070–127 Filter resonance levelIncreasing this value will emphasizethe region near the cutoff frequency.Filter Gain 0– +12 dB Amount of boost for the filter outputLevel 0–127 Output levelL inR inEnhancerEnhancerStep FilterStep FilterMixMix2-BandEQ2-BandEQL outR outL outR outParameter Value DescriptionSens # 0–127 Sensitivity of the enhancerMix # 0–127 Level of the overtones generatedby the enhancerLow Gain -15– +15 dB Gain of the low rangeHigh Gain -15– +15 dB Gain of the high rangeLevel 0–127 Output Level272