Owner's Manual - Roland

Expanding the Memory4. Paying attention to the location of the notches on thememory module and the correct orientation, insert themodule vertically within the guides at either side of thesocket.fig.31-004Checking that memory isinstalled correctly1. Turn on the power, as described in “Turning On the Power”(p. 21).2. Press [MENU] to open the Menu window.3. Press or to select “System,” and then press[ENTER].4. Press [ENTER].5. Press [F4 (System Info)].If you have difficulty inserting the memory module, try tilting ita bit and inserting one end at a time.6. Press [F1 (⇑)] or [F2 (⇓)] to select “SRX Info.”Verify that the screen correctly shows the amount of memoryyou installed.fig.31-007_505. Move the white clips upward, and press them until thememory module is locked in place.fig.31-0057. Press [EXIT] to exit the System screen.6. Use the screws that you removed in step 2 to fasten thecover back in place.Removing the MemoryTo remove the memory module, reverse the installation procedure.1. Simultaneously press outward the white clips located ateither end of the socket.fig.31-006* If the correct amount of memory is not shown, it is possible that thememory is not being recognized properly. Turn off the power asdescribed in “Turning Off the Power” (p. 22), and re-install thememory correctly.Specifications of the expansion memory(DIMM) that can be usedNumber of pins:Speed:Voltage:Capacity:Board height:168-pin100 MHz (PC100 CL=2)133 MHz (PC133 CL=3)3.3 V64/128/256/512 MB38 mm or lessThe Fantom-X has been confirmed to work with standardmemory that meets the above specifications. However, wecannot guarantee that all memory of these specifications willwork correctly. Please be aware that even with identicalspecifications, differences in the design of the memory moduleor the conditions of use may mean that a memory module maynot be usable.2. Remove the memory module from the socket.245