Owner's Manual - Roland

About V-LINKV-LINK ParametersNote Tx ChValue: 1-16MIDI channel that will switch Edirol DV-7PR clips/palettes and willcontrol dissolve time.Clip 1 Note No.Pads 1–16 correspond to Edirol DV-7PR clips (or palettes). Werecommend that you press [PAD SETTING] to access the Pad settingscreen, and set to “Note,” using Quick Setup (p. 161) and set Clip1Note No. to the same value as the “Pad Base Note” setting.Value: 0(C-1)-127(G9)Dissolve TimeControl change number that controls the dissolve time (time overwhich the image switches)Value: OFF, CC1, CC5, CC7, CC10, CC11, CC71-74, CC91-93, Channel AftertouchCtrl Tx ChMIDI channel that will control the Edirol DV-7PR color Cb/Cr,brightness, and video effect switchingValue: 1-16Play Speed CtrlRange of video playback speed The three values are the playbackspeeds (multiples of normal speed) at the left, center, and rightpositions of the pitch bend.Value: 0.0-1.0-2.0, 0.5-1.0-2.0, 0.0-1.0-4.0, 0.5-1.0-4.0, 0.0-1.0-8.0, 0.5-1.0-8.0, 0.0-1.0-16.0, 0.5-1.0-16.0, 0.0-1.0-32.0,0.5-1.0-32.0,0.0-2.0-4.0, 0.0-4.0-8.0, 0.0-8.0-16.0, 0.0-16.0-32.0, -2.0-1.0-4.0, -6.0-1.0-8.0Color Cb CtrlControl change number that controls the Cb color of the imageColor Cr CtrlControl change number that controls the Cr color of the imageBrightness CtrlControl change number that controls the brightness of the imageVFX1–4 CtrlControl change number that controls the video effectPAD MODESelects whether the pads will switch clips or palettes.Value: CLIP, PALETTPress [F1 (Clip)]: switch clipsPress [F2 (Palett)]: switch palettesLocal SwSpecifies whether the internal sound generator is disconnected (OFF)from the pads, or not (OFF).Procedure: Press [F5 (Local Sw)].Value: OFF, ONClip filter(check boxes 1-32)Clips that are checked can be switched. Enable/disable switching foreach clipValue: OFF, ONUsing the Clip FilterFor example, suppose that of the rhythm set you input in thepart used for V-LINK (i.e., the part of the same number as theNote Tx Channel), you want only the kick and snare to switchclips. In this case, check only the clips that correspond to thenote numbers of the kick and snare. The clips will switch whenthe kick or snare plays.Resetting the ImageClip ResetTurn off the image (solid black).Procedure: Press [F3 (Clip Reset)].All ResetThe effect applied to the image will be reset, and brightness, colordifference, etc. will all return to the default value.Procedure: Press [F4 (All Reset)].* For details on clips/palettes, dissolve time, color difference signals (Cb/Cr), refer to the Edirol DV-7PR manual.The Fantom-X does not support the Edirol DV-7PR’s dualstream mode.* VFX2–4 are not supported by the Edirol DV-7PR.Fade CtrlControl change number that controls the output fadeValue: OFF, CC1, CC5, CC7,CC10, CC11, CC71-74, CC91-93, Channel Aftertouch239