Owner's Manual - Roland

Settings Common to All Modes (System Function)System CtrlSys Ctrl 1–4 SourceSystem Control Assign selects the MIDI message used as the SystemControl.System ControlThis function, which departs from previously used methods,and instead allows you to use MIDI messages to change tonesettings in realtime, is called the Matrix Control (p. 80).Similarly, the function allowing you to use MIDI messages tochange multi-effects settings in realtime is called the MultieffectsControl (p. 214).Normally, the Matrix Control is used for making patch settings,and the Multi-effects Control for making settings to patches,rhythm sets, and performances. However, if you do not need tochange the MIDI messages used for matrix control or multieffectscontrol by each patch/rhythm set/performance, or ifyou want to use a specific MIDI message for matrix control ormulti-effects control, you will want to make use of SystemControl. In other words, you could call the System Controlsglobal Matrix Control/Multi-effects Control for the entireFantom-X.You can use up to four System Controls.ValueOFF:The system control knob will not be used.CC01–31, 33–95: Controller numbers 1–31, 33–95For details on control change messages, refer to “MIDIImplementation” (p. 298).PITCH BEND: Pitch BendAFTERTOUCH: AftertouchBackgroundBackground PictureSelect the file that is to be displayed as the screen background.Value:1–16Screen SaverScreen Saver TypeSamplingDefault File TypeSpecifies the file format used when saving a sample.Value: WAV, AIFFPre Sample TimeThe length of sound preceding the moment at which sampling wasmanually or automatically initiated that will be captured in thesample. This lets you prevent the attack portion of the sound frombeing omitted from the sample.Value: 0–1000 msTrigger LevelVolume level at which sampling will begin when Auto Trig is ONA setting of 0 is the minimum.Value: 0–7Gap TimeLength of silence at which the sample will be dividedWhenever there is a silent region longer than the specified time, thesample will be divided at that point, and the next sample numberwill be assigned to the sound that follows. This parameter is validonly when you are using Auto Divide Sampling.Value: 500, 1000, 1500, 2000 msInput SelectInput source of the external input soundValueDIGITAL IN: DIGITAL INPUT jackLINE-L-R: INPUT jacks L/R (stereo)LINE-L: INPUT jack L (mono)MIC: INPUT jack (mono, mic level)Trimming SwitchIf this is turned on, the Start point and End point settings will beautomatically adjusted after sampling is performed, so any silentportions at the beginning or end of the sampled sound are excluded.Value: OFF, ONSkip Back TimeSpecifies how much earlier in time that you want sampling to takeplace when you use Skip Back Sampling. If “OFF” selected, skipbacksampling cannot be performed.Value: OFF, 5s–40sSelect the type of screen saver.Value: 1–16Screen Saver TimeSet the time (minutes) until the screen saver begins working.If this is OFF, the screen saver will not appear.Value: OFF, 5–60 min.233