Owner's Manual - Roland

Settings Common to All Modes (System Function)Functions of SystemParametersThis section explains what the different System parameters do, andalso how these parameters are organized.For details on these settings, refer to “How to Make SystemFunction Settings” (p. 225).Pedal/D BeamD Beam Sens (D Beam Sensitivity)This sets the D Beam controller’s sensitivity. Increasing this valuewill raise the sensitivity.Value: 0–127Control Pedal AssignThis specifies the function of each pedal connected to the PEDALCONTROL jacks.ValueCC01–31, 33–95: Controller numbers 1–31, 33–95For details on control change messages, refer to “MIDIImplementation” (p. 298).BEND UP:BEND DOWN:AFTERTOUCH:OCT UP:OCT DOWN:START/STOP:PUNCH IN/OUT:TAP TEMPO:PROG UP:PROG DOWN:FAVORITE UP:FAVORITE DOWN:ARP SW:RHY START/STOP:CHORD SW:LIVE SET UP:The pitch will rise in semitone steps(maximum 4 octaves) each time you pressthe pedal.The pitch will fall in semitone steps(maximum 4 octaves) each time you pressthe pedal.AftertouchEach pedal press raises the key range inoctave steps (up to 3 octaves higher).Each pedal press lowers the key range inoctave steps (up to 3 octaves lower).The sequencer will start/stop.Manual punch-in/out recording will start/stop.Tap tempo (a tempo specified by the intervalat which you press the pedal).The next sound number will be selected.The previous sound number will be selected.The favorite patch/performance of the nextnumber or bank will be selected.The favorite patch/performance of theprevious number or bank will be selected.Switches the Arpeggio/Rhythm functionon/off.Switch Rhythm pattern playback on/off.Chord function on/off.Switches to the next step within a LiveSetting list.LIVE SET DOWN: Switches to the previous step within a LiveSetting list.LOOP:Loop play On/OffControl Pedal PolaritySelects the polarity of the pedal. On some pedals, the electrical signaloutput by the pedal when it is pressed or released is the opposite ofother pedals. If your pedal has an effect opposite of what you expect,set this parameter to “REVERSE.” If you are using a Roland pedal(that has no polarity switch), set this parameter to “STANDARD.”Value: STANDARD, REVERSEHold Pedal PolaritySelect the polarity of the Hold pedal. On some pedals, the electricalsignal output by the pedal when it is pressed or released is theopposite of other pedals. If your pedal has an effect opposite of whatyou expect, set this parameter to “REVERSE.” If you are using aRoland pedal (that has no polarity switch), set this parameter to“STANDARD.”Range: STANDARD, REVERSEContinuous Hold PedalThis setting determines whether the HOLD PEDAL jack will providesupport for half-pedaling (ON), or not (OFF). When this is set tosupport use of half-pedaling techniques, you can then connect anoptional expression pedal (DP-8, etc.), and employ pedal work toachieve even finer control in performances in which piano tones areused.Value: OFF, ONKeyboardKeyboard VelocitySpecifies the velocity value that will be transmitted when you playthe keyboard. If you want actual keyboard velocity to betransmitted, set this to “REAL.” If you want a fixed velocity value tobe transmitted regardless of how you play, specify the desired value(1–127).Value: REAL, 1–127Keyboard Sens (Keyboard Sensitivity)Adjusts the keyboard’s touch.ValueLIGHT: Light weight synthesizer keyboard likeMEDIUM: StandardHEAVY: Acoustic piano simulationAftertouch Sens (Aftertouch Sensitivity)Specifies the Aftertouch sensitivity. Higher values will allowAftertouch to be applied more easily. Normally you will leave this at“100.”Value: 0–100%226