Owner's Manual - Roland

Adding EffectsSpecifying the multi-effectstructure (MFX Structure)Here’s how to specify how MFX 1–3 will be connected.* This parameter is not found in Patch mode.fig.22-010_50Making Chorus Settings(Chorus)Here we will explain how to make chorus settings in Performancemode. The procedure is the same when making settings in Patchmode.fig.22-011_50For details on these settings, refer to “Making Effect Settings”(p. 206)Structure TypeSpecify how MFX1–3 will be connected.Value: Type 01–Type 16MFX1–3 TYPESelects the multi-effect type of MFX1–3.Value: 0 (Through)–78For details on these settings, refer to “Making Effect Settings”(p. 206)Type (Chorus Type)Selects either chorus or delay.Value0 OFF: Neither chorus or delay is used.1 CHORUS: Chorus is used.2 DELAY: Delay is used.3 GM2 CHORUS: General MIDI 2 chorus* In this setting screen, you can edit the parameters of the chorus/delaythat is selected by the Chorus Type setting. For details on theparameters that can be edited, refer to “Chorus Parameters” (p.293).If a number ( – ) is shown for a parameter in the screen, youcan use the corresponding Realtime Control knob (far left knobis – far right knob is ) to adjust the value of that parameter.When you enter the Chorus screen, the indicator at the right ofthe Realtime Control knobs will go out, and the RealtimeControl knobs can be used to edit the Chorus parameters. If youonce again press the button located at the right of the RealtimeControl knobs so the indicator is lit, the knobs will control theiroriginal functions. When you exit the Chorus screen, theindicator will automatically return to its previous lit state.215