Owner's Manual - Roland

Adding Effects6Part Reverb Send LevelSets the level of the signal sent to reverb for each part.Value: 0–127For the following parameters 7 – 11 , settings can be madeindividually for three systems multi-effects (MFX1–MFX3).12 Chorus TypeSelects either chorus or delay.Value0 (Off): Neither chorus or delay is used.1 (Chorus): Chorus is used.2 (Delay): Delay is used.3 (GM2 Chorus): General MIDI 2 chorus7 MFX Type (Multi-Effects Type)Use this parameter to select from among the 78 available multieffects.For details on multi-effects parameters, refer to “Multi-Effects Parameter” (p. 270).Value: 0 (Through)–788 MFX Output Level (Multi-Effects OutputLevel)Adjusts the volume of the sound that has passed through themulti-effects.Value: 0–1279 MFX Chorus Send Level (Multi-EffectsChorus Send Level)Adjusts the amount of chorus for the sound that passes throughmulti-effects. If you don’t want to add the Chorus effect, set it to“0.”Value: 0–12710 MFX Reverb Send Level (Multi-EffectsReverb Send Level)Adjusts the amount of reverb for the sound that passes throughmulti-effects. If you don’t want to add the Reverb effect, set it to“0.”Value: 0–12711 MFX Output Assign (Multi-Effects OutputAssign)Adjusts the output destination of the sound that has passedthrough the multi-effects.ValueA: Output to the OUTPUT A (MIX) jacks in stereo.B: Output to the OUTPUT B jacks in stereo.13 Chorus Output SelectSpecifies how the sound routed through chorus will be output.ValueMAIN: Output to the OUTPUT jacks in stereo.REV: Output to reverb in mono.M+R: Output to the OUTPUT jacks in stereo, and to reverbin mono.When set to “MAIN” or “M+R,” the OUTPUT jack from whichthe sound is output is set in Chorus Output Assign ( 15 ).14 Chorus LevelAdjusts the volume of the sound that has passed throughchorus.Value: 0–12715 Chorus Output AssignSelects the pair of OUTPUT jacks to which the chorus sound isrouted when Chorus Output Select ( 13 ) is set to “MAIN” or“M+R.”ValueA: Output to the OUTPUT A (MIX) jacks in stereo.B: Output to the OUTPUT B jacks in stereo.When Chorus Output Select ( 13 ) is set to “REV,” this settingwill have no effect.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).For some settings of MFX Structure, the sound that passesthrough the multi-effect will be sent to a different multi-effect,and the MFX Output Assign setting will be ignored.211