Owner's Manual - Roland

Adding EffectsApplying Effects inPerformance ModeIn Performance mode you can use three multi-effects (MFX1, MFX2,MFX3), one chorus, and one reverb. For each of the three multieffects,the chorus, and the reverb, you can specify whether it willoperate according to the effect settings of the performance, oraccording to the effect settings of the patch or rhythm set assigned tothe part you specify. The three multi-effects can be usedindependently, or you can connect two or three of them in series.Specifying How the Sound Will BeOutput (Routing)Here you can make overall settings for effects, and the outputdestination and level of each signal.fig.22-006.eps_502Part Output AssignSpecifies for each part how the direct sound will be output.ValueMFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passesthrough multi-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT Bjack in stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in monowithout passing through multi-effects.PAT: The part’s output destination is determined by thesettings of the patch or rhythm set assigned to thepart.If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).fig.22-007For details on these settings, refer to “Making Effect Settings”(p. 206).Signal Flow Diagram andParameters12 34567771216198 118 118 1114 151718209991310101021If you've set Tone Out Assign to “MFX,” set the MFX OutputAssign parameter ( 11 ) to specify the output destination of thesound that has passed through the multi-effects.• Chorus and reverb are output in mono at all times.• The output destination of the signal after passing through thechorus is set with the Chorus Output Select ( 13 ) and theChorus Output Assign ( 15 ).• The output destination of the signal after passing through thereverb is set with the reverb Output Assign ( 18 ).3 Part Output MFX Select (Part Output Multi-Effects Select)Of the three systems of multi-effects that can be usedsimultaneously, specify which multi-effects will be used.Value: 1–3(MFX-1–MFX-3)4 Part Output LevelSet the level of the signal that is sent to the output destinationspecified by Part Output Assign ( 2 ).Value: 0–1275 Part Chorus Send LevelSets the level of the signal sent to chorus for each part.Value: 0–1271Part SelectSelect the part for which you want to make settings.Value: 1–16210