Owner's Manual - Roland

Adding Effects3Tone Output AssignSpecifies how the direct sound of each tone will be output.Value:MFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passesthrough multi-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT Bjack in stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in monowithout passing through multi-effects.7 MFX Type (Multi-Effects Type)Use this parameter to select from among the 78 available multieffects.For details on multi-effects parameters, refer to “Multi-Effects Parameter” (p. 270).Value: 0 (Through)–788 MFX Output Level (Multi-Effects OutputLevel)Adjusts the volume of the sound that has passed through themulti-effects.Value: 0–127If the Patch Output Assign ( 2 ) is set to anything other than“TONE,” these settings will be ignored.• When the Structure Type parameter has a setting of Type “2”–”10,” the outputs of tones 1 and 2 will be combined with tone 2,and the outputs of tones 3 and 4 will be combined with tone 4.For this reason, tone 1 will follow the settings of tone 2, andtone 3 will follow the settings of tone 4 (p. 63).• If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).If you've set Tone Out Assign to “MFX,” set the MFX OutputAssign parameter ( 11 ) to specify the output destination of thesound that has passed through the multi-effects.• Chorus and reverb are output in mono at all times.• The output destination of the signal after passing through thechorus is set with the Chorus Output Select ( 13 ) and theChorus Output Assign ( 15 ).• The output destination of the signal after passing through thereverb is set with the Reverb Output Assign ( 18 ).4 Tone Output LevelSet the level of the signal that is sent to the output destinationspecified by Output Assign ( 2 , 3 ).Value: 0–1275 Tone Chorus Send LevelSets the level of the signal sent to chorus for each tone.Value: 0–1279 MFX Chorus Send Level (Multi-EffectsChorus Send Level)Adjusts the amount of chorus for the sound that passes throughmulti-effects. If you don’t want to add the Chorus effect, set it to“0.”Value: 0–12710 MFX Reverb Send Level (Multi-EffectsReverb Send Level)Adjusts the amount of reverb for the sound that passes throughmulti-effects. If you don’t want to add the Reverb effect, set it to“0.”Value: 0–12711 MFX Output Assign (Multi-Effects OutputAssign)Adjusts the output destination of the sound that has passedthrough the multi-effects.ValueA: Output to the OUTPUT A (MIX) jacks in stereo.B: Output to the OUTPUT B jacks in stereo.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).12 Chorus TypeSelects either chorus or delay.Value0 (Off): Neither chorus or delay is used.1 (Chorus):Chorus is used.2 (Delay): Delay is used.3 (GM2 Chorus):General MIDI 2 chorus6Tone Reverb Send LevelSets the level of the signal sent to reverb for each tone.Value: 0–127208