Owner's Manual - Roland

Adding EffectsApplying Effects in PatchModeSignal Flow Diagram andParametersIn Patch mode you can use two multi-effects (MFX1, MFX2), onechorus, and one reverb. Multi-effect 1 (MFX1) will operate accordingto the effect settings of the patch or rhythm set assigned to theKeyboard part. Multi-effect 2 (MFX2) will operate according to theeffect settings of the patch or rhythm set assigned to the Pad part.Chorus and reverb will both operate according to the settings of thepatch or rhythm set assigned to either the Keyboard part or the Padpart.fig.22-0052341192078 1191013Specifying How the Sound Will BeOutput (Routing)5121614 1517 18Here you can make overall settings for effects, and the outputdestination and level of each signal.fig.22-004_50116Part SelectSelect the part for which you want to make settings.Value: KBD, PADTone SelectSelect the tone for which you want to make settings.Value: 1–4* This parameter is Rhythm Key Select when a rhythm set is beingselected. You can select the rhythm tone (A0–C8) for which you wantto make settings.For details on these settings, refer to “Making Effect Settings”(p. 206).2 Patch Output AssignSpecifies how the direct sound of each patch will be output.Value:MFX: Output in stereo through multi-effects. You can alsoapply chorus or reverb to the sound that passesthrough multi-effects.A, B: Output to the OUTPUT A (MIX) jack or OUTPUT Bjack in stereo without passing through multi-effects.1–4: Output to the INDIVIDUAL 1–4 jacks in monowithout passing through multi-effects.TONE: Outputs according to the settings for each tone.If you've made settings so that sounds are separately routed tothe INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, but no plugis actually inserted in the INDIVIDUAL 2 jack, the soundsrouted to INDIVIDUAL 1 and INDIVIDUAL 2 will be mixedand output from the INDIVIDUAL 1 jack.• This parameter is Rhythm Output Assign when a rhythm set isbeing selected. You can specifies for each rhythm set how thedirect sound will be output.If the Mix/Parallel parameter is set to “MIX,” all sounds areoutput from the OUTPUT A (MIX) jacks in stereo (p. 230).207