Owner's Manual - Roland

Editing SongsEditing Individual Items ofSequencer Data (Micro Edit)Micro Edit lets you edit individual items of sequencer data recordedin a song, such as MIDI messages and tempo data.Editing Sequencer Data (BasicProcedure in the Microscope)Access the Microscope screen when you want to view the sequencerdata recorded in a song. Each line indicates the location (measurebeat-tick)at which the sequencer data is recorded, and the datarecorded at that location.1. Load the song that contains the sequencer data you want toview/edit (p. 177).2. Press [F8 (Micro Edit)].fig.19-026.eThe Microscope screen appears.Press or to view sequencer data.Select the track or patternDisplays the parameter data at the cursor locationMIDI channel5. Move to the cursor to “Ch/Part,” and select the MIDIchannel of the sequencer data that you want to view.6. Press [F8 (Close)] to close the screen.7. Press or to select the performance data that youwant to edit.8. Press or to select the parameter that you want toedit.9. Turn the VALUE dial or press [INC]/[DEC] to set the value.When editing the Note Number of note or polyphonicaftertouch data, or the On Velocity or Off Velocity of a note, youcan also specify the value by playing a key on the keyboard.• When you press [ENTER], the sequencer data currently shownat the “ ” will be transmitted from the MIDI OUT connector.In the case of a note message, the note will sound when youpress [ENTER].If you want to edit a system exclusive message, refer to“Editing a System Exclusive Message,” below.10. Repeat steps 3–6 to set each parameter you want to edit.11. To close the Microscope screen, press [EXIT].Editing a System Exclusive Message1. Use or to move the cursor to the location of thesystem exclusive message that you want to edit.2. Press .fig.19-027_50The System Exclusive Edit window appears.Sequencer dataLocation of the sequencer data (measure-beat-tick)3. Press [F6] to switch the screen.Each time you press [F6] you will switch between the twoscreens.4. Press [F7 (Trk/Ch Select)] to move the cursor to “Track,”and select the track or pattern whose sequencer data youwant to view/edit.TRK 1–TRK 16: The specified phrase trackTEMPO:BEAT:Tempo trackBeat trackPTN001–PTN100: The specified pattern (pattern mode only)3. Press or to move the cursor to the data that youwant to edit.4. Turn the VALUE dial or press [INC]/[DEC] to edit the value.If you want to add data between “F0:” and “:F7,” move thecursor to that location and press [F3 (Insert)]. A value of “00”will be inserted. Change this to the desired value.To delete data, move the cursor to the relevant location andpress [F2 (Delete)].In order to make efficient use of screen space, display isnormally omitted for locations in which no sequencer data isrecorded.For an explanation of each type of sequencer data, refer to“Sequencer Data Handled by a Phrase Track/Pattern,”below.192