Owner's Manual - Roland

Editing SongsBiasSpecify the amount (number of ticks) by which the sequencer datawill be moved.Value: -4800– +4800StatusSelects the type of data to be shifted in time.ValueALLNOTEPolyphonic AftertouchControl ChangeProgram ChangeChannel AftertouchPitch BendSystem ExclusiveTune RequestPattern CallIf the Track parameter is set to “TEMPO,” the Status parameterwill not be available.Range Min, Range MaxIf you set the Status parameter to “NOTE,” “P.AFT,” “C.C,” or“PROG,” specify the range of data. Set “Range Min” to the lowestvalue of the range, and “Range Max” to the highest value of therange.To shift all notes or polyphonic aftertouch data, set “RangeMin” to “C -1” and “Range Max” to “G9.” To shift C4, set“Range Min” and “Range Max” to “C4.” To shift C3 throughC4, set “Range Min” to “C3” and “Range Max” to “C4.”• To shift all controller numbers, set “Range Min” to “0” and“Range Max” to “127.” To shift all program numbers, set“Range Min” to “1” and “Range Max” to “128.” To shift number4, set “Range Min” and “Range Max” to “4.” To shift numbers 3through 14, set “Range Min” to “3” and “Range Max” to “14.”Thinning Out the Sequencer Data(Data Thin)Continuously variable controllers such as aftertouch, pitch bend, andexpression tend to create unexpectedly large amounts of data whenoperated. Data Thin will strip out redundant data to increase theamount of memory available for the sequencer.fig.19-022_50For details on the settings, refer to “Basic Operation for TrackEditing” (p. 180)Track / Pattern (Source Track)Specifies the track(s) or pattern whose sequencer data will bethinned.ValueALL:TRK 1–TRK 16:Phrase tracks 1–16, the beat track, and the tempotrackThe specified phrase trackPTN001–PTN100: The specified patternCh / PartSelects MIDI channel of the data to be thinned.To thin all sequencer data, set this parameter to ALL. To thinsequencer data of just one specific MIDI channel, select that MIDIchannel.Value: ALL, Ch1–Ch16Measure, For (Edit Range)Specifies the range of measures whose sequencer data will bethinned. If you set “For” to “ALL,” all measures will be specified.Data Thin ValueFor thinning data which incorporates rapid changes, use highersettings. If you don’t want to thin that much data even though it issubject to rapid change, use lower settings.Data Thin TimeIf you are thinning data that changes gradually over time, use highersettings. If you don’t want to thin that much data even though thechanges are gradual, use lower settings.190