Owner's Manual - Roland

Editing SongsExtract ModeSpecifies whether you want to keep the sequencer data at thedestination.ValueMIX:REPLACE:The data at the destination will combine with theextracted data.The data at the destination will be erased andreplaced by the extracted data.If you select “REPLACE,” only the sequencer data on the MIDIchannel specified by the Channel parameter will be the object ofthe operation. Sequencer data of all other MIDI channels will beunaffected.StatusSelects the type of data to be extracted.ValueALLNOTEPoly AftertouchControl ChangeProgram ChangeChannel AftertouchPitch BendSystem ExclusiveTune RequestPattern CallRange Min, Range MaxIf you set the Status parameter to “NOTE,” “P.AFT,” “C.C,” or“PROG,” specify the range of data. Set “Range Min” to the lowestvalue of the range, and “Range Max” to the highest value of therange.To extract all notes or polyphonic aftertouch data, set “RangeMin” to “C -1,” and “Range Max” to “G9.” To extract C4, set“Range Min” and “Range Max” to “C4.” To extract C3 throughC4, set “Range Min” to “C3” and “Range Max” to “C4.”• To extract all controller numbers, set “Range Min” to “0” and“Range Max” to “127.” To extract all program numbers, set“Range Min” to “1” and “Range Max” to “128.” To extractnumber 4, set “Range Min” and “Range Max” to “4.” To extractnumbers 3 through 14, set “Range Min” to “3” and “RangeMax” to “14.”Shifting Performance DataForward and Back (Shift Clock)This function shifts the timing of sequencer data backward orforward in time within a specified area in steps of 1 tick. Slight shiftsof timing can speed up or drag performance.When this function is executed, data that would be moved to apoint before the beginning of the song will automatically shiftto the beginning of the song. If data would be moved to a pointpast the end of the song, additional new measures will becreated automatically as needed. The time signature of thenewly created measures will be the same as that of the measureimmediately preceding.fig.19-021_50For details on the settings, refer to “Basic Operation for TrackEditing” (p. 180)Track / Pattern (Source Track)Specifies the track(s) or pattern whose sequencer data will be movedin units of one tick.ValueALL:TRK 1–TRK 16:TEMPO:Phrase tracks 1–16, the beat track, and the tempotrackThe specified phrase trackTempo trackPTN001–PTN100: The specified patternCh / PartSelects the MIDI channel of the data to be shifted in time.To shift ticks of all sequencer data, set this parameter to ALL. Toshift the sequencer data tick of just one specific MIDI channel, selectthat MIDI channel.Value: ALL, Ch1–Ch16If you set the Track parameter to “TEMPO,” or if the Statusparameter is set to “System Exclusive,” “Tune Request” or“Pattern Call,” the Channel parameter will not be available.Measure, For (Edit Range)Specifies the range of measures in which the sequencer data will bemoved in units of one tick. If you set “For” to “ALL,” all measureswill be specified.189