Owner's Manual - Roland

Editing SongsEditing Sequencer DataOver the Specified Range(Track Edit)Track Edit lets you edit areas of sequencer data that you specify.Basic Operation for Track Editing1. Access the Song Edit screen, and then load the song youwant to edit (p. 177).fig.19-007.eWhile editing a pattern, press [SONG EDIT] and then press [F2(PTN)] to access the Pattern Edit screen.Indicates the name of the currentlyselected song, the measure location,the time signature, and the sequencer status.Measure numberCurrent locationIndicates Loop Play andLoop Recordingon/off (LOOP).Indicates the song’splayback tempo.Measurescontainingsequencer dataMeasurescontaining nosequencer data3. Use the cursor buttons to select the desired function.* You can also select a function by pressing a pad.Quantize->p. 181Erase->p. 183Delete->p. 184Copy->p. 184Insert Measure->p. 185Transpose->p. 185Change Velocity->p. 186Change Channel->p. 186Change Duration->p. 187Merge->p. 188Extract->p. 188Shift Clock->p. 189Data Thin->p. 190Exchange->p. 191Time Fit->p. 191Truncate->p. 191For details on the setting windows of each track editingfunction, refer to the following explanations of each function.4. Set the parameters for each function. Use [CURSOR] tomove the cursor to the desired parameter, and turn theVALUE dial or press [INC]/[DEC] to set the value. Firstcheck the region that is to be affected by the editingoperation, and then make corrections if you want to changeit.5. Press [F8 (Exec)] to execute the operation.When the operation is completed, the display will brieflyindicate “Completed!”If the Song Edit screen shows “QUICK PLAY,” the song has notbeen loaded. If you want to edit this song, press [F8 (Load)] toload the song.* Press [F7 (Temp Song)] to return to the temporary song display.2. Press [SONG EDIT] and then press [F8 (Track Edit)].The Track Edit window appears.fig.19-008_50If you decide not to execute the operation, press [F7 (Cancel)].• If you are not satisfied with the results of executing thefunction, you can press [MENU], and from the Menu windowthat appears, select “Undo Track Edit” to return to the stateprior to executing the operation (Undo/Redo).After executingUndo, you can use Redo to revert to the previous state. Afterexecuting Undo, you can execute Redo by performing the aboveprocedure the above procedure once again.180