Owner's Manual - Roland

Panel DescriptionsRear Panelfig.01-002fig.01-003fig.01-007, 008POWER ON SwitchPress to turn the power on/off. -> (p. 21, p. 22)AC InletConnect the included power cord to this inlet. -> (p. 21)fig.01-004CTL (CONTROL) PEDAL JackYou can connect optional expression pedals (EV-5, etc.) to thesejacks. By assigning a desired function to a pedal, you can use it toselect or modify sound or perform various other control. You canalso connect optional pedal switches (DP series etc.) to sustainsound. -> (p. 25)925* Use only the specified expression pedal (EV-5; sold separately). Byconnecting any other expression pedals, you risk causing malfunctionand/or damage to the unit.HOLD PEDAL JackAn optional pedal switch (DP series etc.) can be connected to thisjack for use as a hold pedal. -> (p. 24)This can also be set so it supports the use of half-pedalingtechniques. So, after connecting an optional expression pedal (DP-8,etc.), you can employ pedal work to achieve even finer control inperformances in which piano tones are used.fig.01-005MIDI Connectors (IN, OUT, THRU)These connectors can be connected to other MIDI devices to receiveand transmit MIDI messages.fig.01-006OUTPUT A (MIX) Jacks (L (MONO), R)These jacks output the audio signal to the connected mixer/amplifiersystem in stereo. For mono output, use the L jack. -> (p. 19)OUTPUT B Jacks (L, R)These jacks output the audio signal to the connected mixer/amplifiersystem in stereo.INDIVIDUAL 1–4 JacksThese jacks output audio signals in mono to an amp or mixer.The setting determining whether these jacks are used as stereoOUTPUT jacks or monaural INDIVIDUAL jacks is made with theOutput Assign setting (p. 207).AUDIO INPUT Jack (L, R)Accept input of audio signals in stereo (L/R) from external devices.If you want to use mono input, connect to the L jack.When recording from a mic, connect it to the L jack, and set InputSelect (p. 141) to “MICROPHONE.”PHONES JackThis is the jack for connecting headphones (sold separately). -> (p.19)fig.01-003aPC CARD SlotA memory card can be inserted here. -> (p. 244, p. 246)931* Carefully insert the memory card all the way in-until it is firmly inplace.USB ConnectorThis connector lets you use a USB cable to connect your computer tothe Fantom-X. -> (p. 218)DIGITAL IN/OUT Connectors (S/P DIF COAXIAL)These are coaxial-type S/P DIF format digital in/out connectors.These connectors input and output a digital audio signal (stereo).The output signal is identical to the signal that is output from theOUTPUT A (MIX) jacks.* S/P DIF is a digital interface format used for consumer digital audio devices.18