Owner's Manual - Roland

Panel DescriptionsFront Panelfig.01-001141 2 4910 12751536811131 D BEAMD BEAMSwitches D Beam function on/off. You can apply a variety of effectsto sounds simply by moving your hand. -> (p. 121)[ASSIGNABLE]You can assign a variety of parameters and functions to D Beam tomodify the sound in realtime. -> (p. 122)[PAD TRIGGER]Instead of striking the pads themselves, you can also use the D Beamcontroller to control the sounding of the pads. -> (p. 122)[SOLO SYNTH]Play the Fantom-X as a monophonic synthesizer. -> (p. 123)* Hold down [SHIFT] and press one of the corresponding buttons toaccess the D BEAM setting screen.2EXT SOURCE[MIX IN]Switches the external input on/off. -> (p. 141)* Hold down [SHIFT] and press this button to access the externalsource setting screen.LEVEL knobControls the volume of the external input.PEAK indicatorThis will light when the volume of the external input is too high.3 VOLUME / V-LINKVOLUMEAdjusts the overall volume that is output from the rear panelOUTPUT A (MIX) jacks and PHONES jack. -> (p. 21)[V-LINK]Switches the V-LINK function on/off. -> (p. 238)* Hold down [SHIFT] and press [V-LINK] to access the V-LINK settingscreen.4REALTIME CONTROL[ ]REALTIME CONTROL knobDepending on the parameter or function that is assigned, you can usethe knobs to modify the sound in realtime. -> (p. 47)[ ], [ ]ASSIGNABLE switchYou can assign a variety of parameters and functions to these twobuttons. Use them to switch the parameters and functions to modifythe sound in realtime. -> (p. 122)[RPS]Switches RPS on/off. -> (p. 203)* Hold down [SHIFT] and press (or rotate) one of the above switches (orknob) to access the corresponding setting screen.[-OCT], [+OCT]Transposes the pitch of the keyboard in 1 octave units (-3- +3 octaves).5ARPEGGIO / RHYTHM[CHORD MEMORY]Switches the CHORD MEMORY on/off. -> (p. 133)[RHYTHM]Switches the RHYTHM on/off. -> (p. 135)[ARPEGGIO]Switches the ARPEGGIO on/off. -> (p. 128)* Hold down [SHIFT] and press one of the corresponding buttons to accessCHORD MEMORY, RHYTHM or ARPEGGIO settings screen.[ARP HOLD]Switches the Arpeggio Hold function on/off.BEAT (Beat Indicator)This blinks in sync with the tempo and beat.6 SEQUENCERPerform sequencer operations such as playback and record.[RESET]Moves the song position to the top. If you press this during playback,you will return to the beginning of the song and stop. -> (p. 165)[BWD]Moves the song position to the first beat of the previous measure. ->(p. 165)[FWD]Moves the song position to the first beat of the next measure. -> (p.165)[Play]Controls sequencer play.16