Owner's Manual - Roland

Editing a Sample4. Either turn the VALUE dial or use [INC][DEC] to set thevalue.• 1–16: The sample or silence to be combined• TYPEValueSample: sample, Time: silent region (specified as time), Beat:silent region (specified as a note value)• BANK (Bank that contains the sample)Value U: user, C: card* This will be displayed only if TYPE is set to Sample.• PRM (Sample number, or the duration/note value of the silentregion)Value: 1–10000 ms (if TYPE is set to Time), note value: 1/32, 1/16T, 1/16, 1/8T, 1/8, 1/4T, 1/4, 1/2, 1/1, 2/1(if TYPE is set to Beat)The note value is based on the BPM of the sample immediatelybefore the silent region.4. Press [WRITE].The Write Menu screen will appear. Make sure that “Sample” ishighlighted.fig.15-023_505. Press [F3 (Sample)] or [ENTER].fig.15-024_50* If there is no sample immediately before the silent region, the currentBPM will be used.5. Use [CURSOR] to select a parameter and repeat step 4.You can press [F6 (Preview)] to audition the selected sample.6. Press [F6 (Exec)].A message will ask you for confirmation.7. To execute, press [F8 (Exec)].* To cancel, press [F7 (Cancel)].Saving a SampleA newly loaded sample, as well as any changes you’ve made in thesettings for a sample will be lost as soon as you turn off the power. Ifyou want to keep such data, you must save it as follows.1. Press [SAMPLE EDIT].2. Press [F1 (Sample List)].Samples displayed as “NEW” or “EDIT” have not yet beensaved.3. Select the sample that you want to save.If you want to select two or more samples, press [F5 (Mark Set)]to add a check mark (✔) to the samples that you want to select.To remove the check mark, press [F4 (Mark Clear)].If you hold down [SHIFT] and press [F5 (Mark Set All)], a checkmark will be added to all samples of the selected bank. If youhold down [SHIFT] and press [F4 (Mark Clr All)], check markswill be removed from all selected samples.The edit screen for the selected sample will appear.You can press [F8 (Preview)] to audition the selected sample.If you have selected more than one sample, a message will askyou to confirm the writing operation. Samples will be writteninto the identical number corresponding to each bank of thesample list. Sample names will be assigned automatically. Ifyou want to write the samples, press [F8 (Exec)]. If you decideto cancel, press [F7 (Cancel)].6. Assign a name to the sample.For details on assigning names, refer to “Assigning a Name”(p. 36)7. When you have finished inputting the name, press [F8 (Write)].A screen will appear allowing you to select the writedestinationsample.8. Turn the VALUE dial, or use [INC][DEC] or [F2 (User)][F3(Card)] to select the write destination and sample number.The write destination can be either the Fantom-X’s internal usermemory (User), or a memory card (Card).9. Press [F8 (Write)].A message will ask you for confirmation.Never switch off the Fantom-X while data is being saved.10. Press [F8 (Exec)] to execute the save operation.* To cancel the operation, press [F7 (Cancel)].• You can't save by overwriting another sample.• Stereo samples must be saved to two consecutive samplenumbers.159