Owner's Manual - Roland

Editing a Sample3. Press [F5 (Time Strtch)].fig.15-020_503. Press [F3 (Chop)].fig.15-021_504. Press or to select the parameter.• Edit Time StretchBPM: Change the BPM of the sample to the BPM youspecify.Time: Specify the length of the sample as a time value.Rate: Specify the length relative to the current length ofthe sample.Value: 50.0–200.0%• TypeLower settings of this value will make the sound more suitablefor faster phrases, and higher settings will make the soundmore suitable for slower phrases.Value: TYPE01–TYPE10• Quality AdjustMake fine adjustments to the tonal quality of the Time Stretch.Value: 1–105. Use VALUE dial or [INC/DEC] to specify the tempo/length.When setting the BPM (tempo) value, you can hold down[SHIFT] and turn the VALUE dial, or use [INC] [DEC] to adjustthe value to the right of the decimal point.6. Press [F8 (Exec)].A message will ask you for confirmation.7. To execute, press [F8 (Exec)].The length of the sample will be changed as specified.* To cancel, press [F7 (Cancel)].Procedure for Dividing a SampleYou can freely specify the point(s) at which the sample is to bedivided.4. Press or to move the cursor to “Current Address.”5. Either turn the VALUE dial or use [INC], [DEC] to move thepoint.6. At the location where you want to divide the sample, press[F4 (Add Point)].The current location will be the dividing point.7. Repeat steps 5 and 6 to specify other dividing points asdesired.You can specify up to 15 locations at which to divide thesample; i.e., the sample will be divided into a maximum of 16pieces.8. Audition the sample as described in the section“Auditioning the divided samples.”If you want to re-make settings, press [F7 (Cancel)], and moveor delete the point (p. 158).9. Press [F8 (Exec)].A message will ask you for confirmation.10. To execute the division, press [F8 (Exec)].* To cancel, press [F7 (Cancel)].When you execute the Chop operation, a message will askwhether you want to execute Create Rhythm.* The divided samples will be added to the sample list.Dividing a Sample intoNotes (Chop)The chop function divides a sample waveform into separate notes.11. If you want to execute Create Rhythm, press [F8 (Exec)].For the rest of the procedure, refer to “Create a Rhythm Set(Create Rhythm)” (p. 152).12. If you don’t want to execute Create Rhythm, press [F7(Cancel)].* The Create Rhythm function (p. 152) makes it easy to create a rhythmset from a chopped sample.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.2. Press [F3 (Sample Modify)] to access the Sample Modifywindow.157