Owner's Manual - Roland

Editing a SampleMaximizing the Volume of aSample (Normalize)3. Press [F4 (Amp)].fig.15-019_50This operation raises the level of the entire sample as much aspossible without exceeding the maximum level. In some cases, thevolume of a phrase you resampled (p. 143) will be lower than thevolume of the original phrase. In this case, it is a good idea to boostthe volume by executing the Normalize operation.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.2. Press [F3 (Sample Modify)] to access the Sample Modifywindow.3. Press [F3 (Normalize)].fig.15-018_504. If you want to replace the current sample with thenormalized sample, press [F6 (Over Write)] to display the“✔” symbol.5. Press [F8 (Exec)].A message will ask you for confirmation.6. To execute, press [F8 (Exec)].* To cancel, press [F7 (Cancel)].4. Use VALUE dial or [INC] [DEC] to set the value.• Rate 1–4: Specifies the rate of volume boost.This specifies how much boost will be applied relative to thecurrent volume. The entire sample you select will be boosted.Value: 0–400%5. If you want to specify a point, press [F5 (Point)] to light itinto red. Press or to select a parameter, and thenuse VALUE dial or [INC] [DEC] to set the value.• Current Point:Specifies the currently selected point. Beginningnear the start point, the points will be numbered 1, 2, 3, or 4.• Point 1–4: Location of the current point• Rate 1–4: Amplification ratio of the current pointSpecifies how the volume of each point is to be boosted relativeto the current value.Value: 0–400%6. If you want the edited sample to replace the current sample,press [F6 (Over Write)] to display the “✔” mark.7. Press [F8 (Exec)].A message will ask you for confirmation.8. To execute, press [F8 (Exec)].* To cancel, press [F7 (Cancel)].AmpThis operation applies an envelope (time-variant change) to thevolume of the sample.You can also adjust the volume of the entiresample.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.2. Press [F3 (Sample Modify)] to access the Sample Modifywindow.Stretching or Shrinking aSample (Time Stretch)This operation stretches or shrinks the sample to modify the lengthor tempo. You can stretch or shrink the sample by a factor of one halfto double the original length.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.2. Press [F3 (Sample Modify)] to access the Sample Modifywindow.156