Owner's Manual - Roland

Editing a Sample6. When you’ve finished setting the Original Key of allsamples, create the multisample as described in “Creatinga Multisample (Create Multisample)” (p. 153).Unloading a Sample(Unload)In the Sample Edit screen you can press [F1 (Unload)] to unload thecurrently selected sample and return to the previous screen.Removing UnwantedPortions of a Sample(Truncate)This operation cuts the portions of the sample that are earlier thanthe Start Point and later than the Loop End Point.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.Boosting or Limiting theHigh-frequency Range ofthe Sample (Emphasis)In some cases, the audio quality will be improved if you boost thehigh-frequency range of an imported sample. Also, the highfrequencyrange of the sample may be emphasized when you use asampler made by another manufacturer. In this case, you canminimize the change in tonal character by attenuating the highfrequencyrange.* You cannot execute this with more than one sample selected.1. Press [SAMPLE EDIT] to access the Sample Edit screen.2. Press [F3 (Sample Modify)] to access the Sample Modifywindow.3. Press [F2 (Emphasis)].fig.15-017_502. Press or to select the parameter.• Start Point: Specifies the sample start point.• End Point: Specifies the sample end point.3. Either turn the VALUE dial or use [INC] [DEC] to set thevalue.4. Press [F3 (Sample Modify)] to access the Sample Modifywindow.5. Press [F1 (Truncate)].fig.15-016_504. Either turn the VALUE dial or use [INC] [DEC] to select theemphasis type.• PreEmphasis: Emphasizes the high-frequency range.• DeEmphasis: Attenuates the high-frequency range.5. If you want to replace the current sample with theemphasized sample, press [F6 (Over Write)] to display the“✔” symbol.6. Press [F8 (Exec)].A message will ask you for confirmation.7. To execute, press [F8 (Exec)].6. If you want to replace the current sample with the truncatedsample, press [F6 (Over Write)] to display the “✔” symbol.* To cancel, press [F7 (Cancel)].7. Press [F8 (Exec)].A message will ask you for confirmation.8. To execute the Truncate operation, press [F8 (Exec)].* If you want to cancel without executing, press [F7 (Cancel)].155