Owner's Manual - Roland

Editing a Sample1. Press [SAMPLE LIST] to access the Sample List screen,and select the sample(s) that you want to include in yournew multisample.If you want to select two or more samples from the sample list,press [F5 (Mark Set)] to add a check mark (✔) to each sample.Pressing [F4 (Mark Clear)] will clear the check mark.You can press [F8 (Preview)] to audition the selected sample.If the total number of marks exceeds 128, the multisample willbe created from the 128 lowest-numbered samples.You cannot create a multisample using samples from more thanone group.2. Press [F7 (Load Utility)], and then press [F3 (Create MultiSample)].fig.15-xxx_50The Create Multisample Name screen will appear.8. When the data has been written, the Assign to Keyboardscreen will appear.fig.15-015b9. If you want to use the multisample as a patch, press [F8(Exec)].If you decide to cancel, press [F7 (Cancel)].Never turn off the power while data is being written.* You can’t listen to a multisample unless it’s assigned to a part as apatch. If you press [F7 (Cancel)] at this point, the multisample will besaved, but you’ll need to perform the additional step of assigning thesaved multisample to the keyboard in order to actually play it (p. 152).Assigning a multisample to thedesired keys3. Assign a name.For details on assigning names, refer to “Assigning a Name”(p. 36)4. When you have finished inputting the name, press [F8(Write)].A screen will appear, allowing you to select the destination forthe write.5. Either turn the VALUE dial or use [INC] [DEC] to select thewrite destination.Multisamples consisting of user samples will be written to User,and multisamples consisting of card samples will be written toCard.6. Press [F8 (Write)].A message will ask you to confirm the operation.7. If you are sure you want to write the multisample, press [F8(Exec)].If you decide to cancel, press [F7 (Cancel)].Never switch off the Fantom-X while data is being saved.In order to assign a multisample to the desired keys, you’ll need toset the Original Key of each sample to the appropriate keys. Then,when you execute the Create Multisample operation, the Fantom-Xwill assign the samples to the keyboard and set the split pointsautomatically.1. Press [SAMPLE LIST] to access the Sample List screen,and select one of the samples within the multisample.2. Press the [SAMPLE EDIT] button to access the Sample Editscreen.3. Press [F2 (Sample Param)] to access the Sample Paramscreen.4. Set the Original Key to the note number of the key to whichyou want to assign the sample.You can also specify a note number by playing a note on thekeyboard.5. Press the [SAMPLE EDIT] button to return to the SampleEdit screen, and set the Original Key for the other samplesin the same way.When creating a multisample, you’ll need to change theOriginal Key of more than one sample. After you’ve made thesetting for the first sample, you can simply press [SAMPLELIST] to access the Sample List screen, select another sampleand press [ENTER] to go directly to the Sample Param screen.* The Original Key you specify here needs to be saved for each sample.154