Owner's Manual - Roland

Editing a SampleMaking Settings for Sample(Sample Parameters)fig.15-007Start P.LoopStart P. End P.Here you can make various settings for the sample.1. Press [SAMPLE LIST] and select the sample that you wantto edit (p. 146).2. Press [SAMPLE EDIT] to access the Sample Edit screen,and press [F2 (Sample Param)].fig.15-004_50fig.15-008REV-ONE (Reverse One-shot)The sample will be played back only once from the End point tothe Start point in the reverse direction.Start P.LoopStart P. End P.• Loop TuneSpecifies the pitch of the loop region.Value: -50– +503. Press or to select a parameter.4. Use VALUE dial or [INC], [DEC] to edit the value.• Loop Modefig.15-005fig.15-006Specifies how the sample will be played.ValueFWD (Forward)After the Sample played back from the Start point to the Endpoint, it will then be repeatedly played back in the forwarddirection, from the Loop Start point to the End point.Start P.ONE-SHOTThe sample will be played back only once, from the Start pointto the End point.Start P.REV (Reverse)LoopStart P. End P.LoopStart P. End P.When the sample has been played back from the End point tothe Start point, it will be repeatedly played back in the reversedirection, from the Loop Start point to the Start point.* Make fine adjustments in one-cent (1/100 semitone) increments.• Original KeyNote number that will play the sample at the pitch at which itwas sampled.Value: 0 (C-1)–127 (G9)• BPM (TEMPO)Specifies the original tempo of the sample.Value: 5.00–300.00* In order to synchronize the tempo, Wave Temp Sync (p. 63) must beturned on.* When setting the BPM (tempo) value, you can hold down [SHIFT]and turn the VALUE dial, or use [INC] [DEC] to adjust the value tothe right of the decimal point.• Time Stretch TypeSpecifies how the tempo will be synchronized. Decreasing thisvalue will optimize the sound for more rapid phrases, andincreasing this value will optimize the sound for slowerphrases.Value: TYPE01–TYPE10• Start FineFine adjustment of the Start point.Value: 0–255• Loop Start FineFine adjustment of the Loop Start point.Value: 0–255• Loop End FineFine adjustment of the End point.Value: 0–255* By pressing [F7 (Reset Grid)] you can reassign the sample gridaccording to the specified start point and BPM. To execute, press [F8(Exec)].5. Press [EXIT] when you are finished.150