Owner's Manual - Roland

Creating a PerformanceTempofig.09-018_50Control Switch Settings (Ctrl Switch)You can change controller switch on/off settings for each patch inthe performance.1. In the Control Setting (Performance) screen, press [F7 (CtrlSwitch)].fig.09-012_50For details on these settings, refer to “Selecting the ParameterControlled by the Realtime Controllers or D BeamController (Control Setting)” (p. 114).Recommended TempoIf you want the sequencer tempo to change when you switchPerformances, specify the tempo that will follow this change. Thissetting is valid when the Seq Tempo Override parameter is “ON.” Inorder to enable this setting, turn on the Tempo Override parameter(p. 227).Value: 20–250* This value is specified independently for each performance. This meansthat when you switch performances, the tempo setting of the Fantom-X will change.* The sequencer tempo will be overwritten to the new tempo when youswitch performances.MFX Ctrl Chfig.09-019_502. Use [CURSOR] to move the cursor to the parameter youwish to modify.3. Turn the VALUE dial or press [INC]/[DEC] to get the valueyou want.4. Repeat steps 2-3 to set each parameter you want to edit.5. Press [F8 (EXIT)] to return to the previous screen.Control Bender (Control Pitch Bend Switch)For each part, specify whether MIDI Pitch Bend messages will betransmitted (ON), or not (OFF).Value: OFF, ONControl Aftertouch (Control Aftertouch Switch)For each part, specify whether MIDI Aftertouch messages will betransmitted (ON), or not (OFF).Value: OFF, ONControl Modulation (Control ModulationSwitch)For each part, specify whether MIDI Modulation messages will betransmitted (ON), or not (OFF).Value: OFF, ONControl Hold Pedal (Control Hold Pedal Switch)For details on these settings, refer to “Selecting the ParameterControlled by the Realtime Controllers or D BeamController (Control Setting)” (p. 114).MFX 1–3 Control ChannelSelect the channel to which the multi-effect will be applied. Controlto modify multi-effects parameters in realtime, when MFX1–3 Sourceparameter is set to “Prf.” Set to “OFF” when the Multi-effectsControl is not being used.Value: 1–16, OFFFor each part, you can specify whether control messages from apedal connected to the HOLD PEDAL jacks will be transmitted(ON), or not (OFF).Value: OFF, ONControl Pedal (Control Pedal Switch)For each part, you can specify whether control messages from apedal connected to the CONTROL PEDAL jacks will be transmitted(ON), or not (OFF).Value: OFF, ON118