Owner's Manual - Roland

Creating a PerformanceLFO Osc 2 Pitch DepthSpecifies the depth to which the LFO will modulate the OSC2 pitch.Value: -63–+63LFO Osc 1 Pulse Width DepthSpecifies the depth to which the LFO will modulate the pulse widthof the OSC1 waveform.* The Pulse Width is activated when “SQR” is selected with OSC1/2waveform.Value: -63–+63LFO Osc 2 Pulse Width DepthSpecifies the depth to which the LFO will modulate the pulse widthof the OSC2 waveform.* The Pulse Width is activated when “SQR” is selected with OSC1/2waveform.Value: -63–+63Range (Solo synth range)Specifies the range in which the pitch of the solo synth will vary.Value: 2 OCTAVES, 4 OCTAVES, 8 OCTAVESD Beam (Assignable)By assigning a variety of functions to the D Beam controller you canapply different effects to the sound in real time.fig.09-015_50Type (Assignable Type)Specifies the function controlled by the D Beam controller.ValueCC01–31, 33–95: Controller numbers 1–31, 33–95For more information about Control Change messages, pleaserefer to “MIDI Implementation” (p. 298).Bend Up: Controls the pitch as specified by the “PitchBend Range Up” setting (p. 67).Bend Down: Controls the pitch as specified by the “PitchBend Range Down” setting (p. 67).Start/Stop: Starts/Stops the sequencer.TAP Tempo: Tap tempo (a tempo specified by the interval atwhich you move your hand over the D Beamcontroller).Arp Grid: Arpeggio GridArp Duration: Adjusts the duration of each arpeggiated noteArp Motif: Arpeggio MotifArp Oct Up: The range in which the arpeggio is sounded willrise in steps of an octave (maximum 3 octaves).Arp Oct Down: The range in which the arpeggio is sounded willlower in steps of an octave (maximum 3octaves).Range Min (D Beam Range Lower)Specify the lower limit of the range of the D Beam controller.Value: 0–127Range Max (D Beam Range Upper)Specify the upper limit of the range of the D Beam controller. Bysetting Range Max below Range Min you can invert the range ofchange.Value: 0–127For details on these settings, refer to “Selecting the ParameterControlled by the Realtime Controllers or D BeamController (Control Setting)” (p. 114).The settings for the ASSIGNABLE are saved independently foreach performance as part of the performance settings. This letsyou create performances that make effective use of controllersettings.116