Owner's Manual - Roland

Creating a Performance[F4 (Offset)]fig.09-004_50Part Release Time OffsetAdjusts the TVA/TVF Envelope Release Time for the patch orrhythm set assigned to a part.Value: -64– +63Patches also contain a Release Time Offset setting (p. 62). Thefinal TVA Envelope release time value is therefore the sum ofthe tone’s TVA Envelope Time 4 setting, the patch’s ReleaseTime Offset, and the part’s Release Time Offset. If the tone’sTime 4 parameter is set to “127” (maximum), there will be nochange in the Release Time Offset, even when this is set to apositive value.The same applies to the TVF envelope.For details on these settings, refer to “Adjusting theParameters of Each Part” (p. 107).Part Cutoff OffsetAdjusts the cutoff frequency for the patch or rhythm set assigned toa part.Value: -64– +63Part Decay Time OffsetAdjusts the TVA/TVF Envelope Decay Time for the patch or rhythmset assigned to a part.Value: -64– +63[F5 (Key Range)]fig.09-005_50Patches also have a Cutoff Offset setting (p. 61). The final Cutofffrequency value is the sum of the tone Cutoff Frequency valueand the patch and part Cutoff Offset values. If the tone’s cutofffrequency is already set to “127” (maximum), there will be nochange produced by setting the Cutoff Offset to a positivevalue.Part Resonance OffsetAdjusts the Resonance for the patch or rhythm set assigned to a part.Value: -64– +63Patches also have a Resonance Offset setting (p. 62). The finalResonance value is the sum of the tone Resonance value and thepatch and part Resonance Offset values. If the tone’s resonanceis already set to “127” (maximum), there will be no changeproduced by setting the resonance offset to a positive value.Part Attack Time OffsetAdjusts the TVA/TVF Envelope Attack Time for the patch orrhythm set assigned to a part.Value: -64– +63Patches also contain the Attack Time Offset setting (p. 62). Thefinal TVA Envelope attack time value is therefore the sum of thetone’s TVA Envelope Time 1 setting, the patch’s Attack TimeOffset, and the part’s Attack Time Offset. If the tone’s Time 1parameter is already set to “127” (maximum), there will be nochange produced by setting the Attack Time Offset to a positivevalue.The same applies to the TVF envelope.For details on these settings, refer to “Adjusting theParameters of Each Part” (p. 107).Specifies whether the controller (keyboard) section will be connectedto the internal sound generator and MIDI OUT regardless of thecurrent part. Normally, you will leave this off, but you can turn it onif you want to layer sounds.Value: ON, OFFKeyboard SwitchSpecifies, for each part, whether or not the keyboard controllersection will be connected to the internal sound generator.Value: On, OFFKeyboard Range Lower (Part Keyboard RangeLower)Specifies the lowest note that the tone will sound for each part.Value: C-1–UPPER110